Base
Fitter
Fixture
Ground Wire
Set Screw
Fixture Wire
Set Hole
Set Hole
Wire Nut
Mounting Screw
Pier Mount
Wall Anchor
Please drill the set holes
on the pier mount
1. Attach the fitter of the fixture to the pier mount and mark the set holes positions of the fitter on the
pier mount, and place the pier mount to the base and mark the set holes position of the pier mount
on the base.
2. Place the light fixture aside. Drill the marked positions of the set holes on the pier mount and the
base by power tool.
NOTE: The set holes which drilled on the pier mount must be smaller than the set screws.
3. Thread the wall anchors into the holes, place the pier mount to the base, and then thread the
mounting screws through the set holes into the wall anchors.
4. Make wire connections with wire nuts:
--- The black wire from light to the black wire from power souce.
--- The white wire from light to the white wire from power source.
--- The ground wire to the ground wire of the power source.
Carefully tuck wires back into the pier mount.
5. Attach the fitter of the fixture to the pier mount, and match the set holes of the fitter and pier mount.
Secure them with the set screws.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0019 / T0038
120511
-
1
Cascadia T0019 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Gama Sonic GS-105B-FPW Owner's manual
-
Craftmade Z9215-MN-LED Installation guide
-
Kozyheat #944 Owner's manual
-
-
Kichler Lighting 49478RZ User manual
-
-
-
Quadra-Fire HV-IPI QV-ST User manual
-
-
