KT&C DN302U Operating instructions

KT&C
Brand
KT&C
Model
DN302U
Category
Security camera accessories
Type
Operating instructions
NIGHT VISION DSP COLOR CCTV CAMERA
OPERATION MANUAL
KEY FEATURES
These CCD video cameras employ a 960H 1/3" CCD solid-state image device which provides
superior performance.
These cameras can be installed easily in most indoor and outdoor locations with a very low
current consumption of 300mA (400mA) or less.
These cameras are not only easy to install but achieve an excellent reliability record.
ACCESSORIES FURNISHED
SPECIFICATIONS
M238-(D)N302-002
Thank you for choosing our high quality camera.
Before attempting to connect operate this unit, please read and follow these instructions.
Accessories
Concealed
Bracket
Mounting
Bracket
Screw
Coin Hole
Bolt
Washer Sun Shield Manual
Q'ty - 1 3 1 1 1 1
Option 1 - - - - - -
Signal Format NTSC PAL NTSC PAL
Image Device 1/3” 960H High Sensitivity CCD
Scanning System 2 : 1 Interlace
H.Resolution 750TV Lines
Scanning
Frequency
15.734KHz(H),
59.94Hz(V)
15.625KHz(H),
50Hz(V)
15.734KHz(H),
59.94Hz(V)
15.625KHz(H),
50Hz(V)
Total Pixels 1020(H) X 508(V) 1020(H) X 596(V) 1020(H) X 508(V) 1020(H) X 596(V)
Effective Pixels 976(H) X 494(V) 976(H) X 582(V) 976(H) X 494(V) 976(H) X 582(V)
Electronic
Shutter Speed
1/60 s ~ 1/100,000 s 1/50 s ~ 1/100,000 s 1/60 s ~ 1/100,000 s 1/50 s ~ 1/100,000 s
S/N Ratio More than 50dB(AGC OFF)
Gamma r =0.45
Min. Illumination 0 Lux (IR LED ON)
Sync System Internal
Video Output 1.0 Vp-p Composite 75(Ω) unbalanced
Day / Night Electronic D/N True D/N with ICR Mechanism
Lens Board
IP Rating IP67
IR LED 850nm, 20ea
IR Beam Range Up to 30 m
Input Power
Source
12VDC ±10%, Max 300mA (IR LED ON) 12VDC ±10%, Max 400mA (IR LED ON)
Operating
Temperature
-40°F ~ 140°F (-40°C ~ 60°C)
Storage
Temperature
-4°F ~ 140°F (-20°C ~ 60°C)
Operating
Humidity
Less than 80%
Weight Approx. 362g
Dimension (mm) Ø58.3 x 100.5 (w/o Sunshield)
Specications and designs are subject to change for improving the functionality of this product without notice.
When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device may receive interference that can cause affect the opration of this equipment.
Note -
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.”
Caution -
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to
operate the equipment.
1. A regulated DC12V 1A power supply is recommended to ensure the best picture quality and
stable operation.
An unregulated power supply can cause damage to the camera.
Using an unregulated power supply will void the product warranty.
2. It is recommended that the camera is used with a monitor that has a CCTV quality 75Ω video
impedance level. If your monitor is switched to high impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal componets. Refer
servicing to your dealer.
4. Never face the camera towards the sun or any bright or reflective light, which may cause smear
on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
DIMENSIONS
CONNECTION
CAMERA MOUNTING POSITION
Unit : mm
Concealed Bracket
112 ~ 102
Option
Cable Concealed
Thru Bracket(Option)
When using the cable concealed bracket, it is not
able to install on the ceiling.
Please assemble a coin
hole bolt as shown above.
DIY CABLE CONNECTION
BNC FEMALE VIDEO OUT
DC +12V MALE
VIDEO IN
DC12V REGULATED
POWER SUPPLY
BNC FEMALE VIDEO OUT
DC +12V MALE
VIDEO IN
Photocell
20 LED
  • Page 1 1
  • Page 2 2

KT&C DN302U Operating instructions

KT&C
Brand
KT&C
Model
DN302U
Category
Security camera accessories
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents