INSTALLATION
DECORATIVE CRUSHED SHALE
This Shale is provided to enhance the look and feel
of your log set and fireplace. Its only function is to
be decorative. Simply spread the Crushed Shale on
your fireplace floor around the bottom of your log
set burner/grate to give the appearance of burnt ash.
It can also be used to cover your gas supply line co-
ming from the wall to your burner.
Caution: Never place the shale, or any other object
(not provided with your gas log set and instructed
for that purpose) onto the burners of the unit.
Be creative in the placement. You do not have to use
all of the supplied shale.
CRUSHED SHALE SHOWN
AS PROVIDED
GRANULE PLACEMENT - Vent Free Sets
For Vented Decorative Gas Log Sets, see other side of this sheet.
A.
B.
D.Attach back log Standoff (if removed )
(See Figure 1
)
Figure 1 Granule and Ember
Figure 2. Front View
GRANULE AND EMBER PLACEMENT
Spread granules (Crushed Shale) over the installed burner pan. Granules
should be sloped to the same angle as the burner pan filling the entire pan.
(See Figure 1)
Spread the glowing embers evenly over the top of the granules covering
the entire surface area, concentrating on the front and sides of the burner
pan for the most realistic burning effect.
Placement
C. Place log grate (if removed) over the burner pan aligning as shown.
(See Figure 2)
to the back part of the grate.
NOTE: A hammer may be used to tap the back log stand-off in place. It may
be necessary to squeeze the back log stand-off with pliers after attaching to
the grate.
To properly replace existing or missing Burner Media in Pan-type
Vented Decorative Gas log sets, follow these steps:
RMH-130-ISCSE
(Remove any existing media from the pan before installing any new mat-
erial.)
For Vent Free Gas Log Sets, see other side of this sheet.
/