Trywell Brushed Bar Prep Kitchen Sink Faucet Installation guide

Brand
Trywell
Model
Brushed Bar Prep Kitchen Sink Faucet
Type
Installation guide
INSTALLATION GUIDE
Single Handle Kitchen Faucet
Model No.:
Thank you for your purchase
Prior to Installation
Tools you will need
Congratulations on choosing a kitchen faucet which is constructed from 100% solid stainless
steel. We hope that this faucet will bring you satisfactory use experience.
Make sure the water flow is not restricted by sand, slit or other blockages. Blockages must be
cleared for normal faucet operation.
Make sure all pre-installed hoses are tightly screwed into the faucet.
▲ This installation manual is subject to change without further notice.
TR01Simplex(TW-K001U)
Dimension Drawing
Diagram and Parts List
Faucet Installation Procedures
Step 1
Step 2
Insert faucet body on the pre-drilled hole 1-3/8"
Make sure all pre-installed hoses
(#23) are tightly screwed into the
faucet. Unscrew the locking nut,
metal gasket and rubber gasket.
Step 3
Step 4
Place rubber gasket and
metal gasket, thread metal
nut onto the mount pipe and
tighten the screws until
snug.
Check if O-rings are installed on
both ends of the hot&cold
waterlines. Apply Teflon tape and
screw hot/cold waterline
connections until snug. Check for
leaks before proceeding to the
next step.
Step 5
Turn the faucet on and check if it works properly.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Trywell Brushed Bar Prep Kitchen Sink Faucet Installation guide

Brand
Trywell
Model
Brushed Bar Prep Kitchen Sink Faucet
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents