Installation Instructions
87-06 Jeep Wrangler TJ YJ
Page
1
of
1
Please read and understand all instructions before starting this installation. The manufacturer holds no
responsibility for any personal injury or damage sustained to vehicle during installation or use of this product.
CAUTION: This product is designed primarily to enhance the appearance of this vehicle and in no way will
prevent damage to vehicle, personal injury or death in the event of an accident.
STEP 1: REMOVE
1) Remove the front plastic frame/stabilizer bar cover. (Fig 1)
2) Remove front bumper hardware and tow hooks (if equipped). (Fig 2)
3) Remove the front (only) stabilizer mounting bolt. (Fig 2)
STEP 2: INSTALL
Install winch plate using the supplied hardware.
NOTE:(TJ) 4- ½ x 1 ½ bolts (Torque to 75 ft. lbs)
(YJ) 4- ½ x 1 ½ bolts (Torque to 75 ft. lbs)
TOOLS REQUIRED:
18mm Wrench & Socket
Flat Screwdriver or Panel clip pliers
Phillips Screwdriver
HARDWARE INCLUDED:
A. (2)10 x 50 mm Bolt
B. (2)10 x 25 mm Bolt
C. (2)12 x 40 mm Hex Head Bolt
D. (4)10 mm Lock Washer
E. (2)12 mm Lock Washer
F. (2)10 mm Flat Washer
G. (2)12 mm Flat Washer
H. (2)10 x 1.5 Lock Nut
I. (2)¾” Spacer
J. (4)½”-13 x 1 ½ “ Bolt
K. (4)½” Flat Washer
L. (4) ½” Lock Washer
COMPONENTS INCLUDED:
A. Winch Mounting Plate