LG REFRIGERATION
HOME APPLIANCES
▲
!
Make sure the location of the water supply pipe is within the marked range.
▲
!
Before connecting the power, always make sure to ground the product. (If
the product is not grounded, the user may be able to feel the electricity due
to the minute leakage current when touching the refrigerator door handle or
side corner even when there is no issue with the product.)
▲
!
Do not ground the product to gas pipe, plastic water pipe or telephone wire
etc. It can cause electric shock and explosion.
Power connection
The location of the 115V 60Hz power
connector must be located on the rear side
of the product as shown in the picture.
When installing the product, make sure to
check whether the cord is hung on the hook
on the rear side so that it is not pressed on
the refrigerator. Damaged power cord can
cause a re.
Installation space for
water supply pipe
Place the water hose for ice maker and water dispenser as shown in the picture, and
prepare hose to come up from the oor. (Copper pipe with diameter of 5/16”(8mm) is
recommended for the water hose.) If the water pipe and water hose is located far from
the product, bury the water hose on the oor and provide appropriate treatment.
CONNECTING POWER AND SECURING SPACE FOR WATER SUPPLY PIPE
WATER
Select a place where a water supply can be easily connected for the automatic
NOTE
• The water pressure must be 20 – 120 psi or 138 – 827 kPa or 1.4 – 8.4 kgf/cm². If the
refrigerator is installed in an area with low water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
ELECTRICITY
The refrigerator should always be plugged into its own individual properly grounded
electrical outlet rated for 115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. This
provides the best performance and also prevents overloading house wiring circuits which
could cause a re hazard from overheated wires. It is recommended that a separate circuit
serving only this appliance be provided.
WARNING
• To reduce the risk of electric shock, do not install the refrigerator in a wet or damp area.
FLOORING
To avoid noise and vibration, the unit must be leveled and installed on a solidly
constructed oor. If required, adjust the leveling legs to compensate for the unevenness
of the oor. The front should be slightly higher than the rear to aid in door closing.
Leveling legs can be turned easily by tipping the cabinet slightly. Turn the leveling legs to
the left to raise the unit or to the right to lower it.
NOTE
• Installing on carpeting, soft tile surfaces, a platform or weakly supported structure is not
recommended.
AMBIENT TEMPERATURE
Install this appliance in an area where the temperature is between 55°F (13°C) and 110°F
(43°C). If the temperature around the appliance is too low or high, cooling ability may be
adversely affected.
CHOOSING THE PROPER LOCATION
QUICK INSTALL & CLEARANCES
For full installation directions/clearances please refer to
the corresponding User Manual and Installation Guide.
IMPORTANT
LFXS28566_
28 cu.ft. 3-Door Refrigerator with PrintProof™
DIMENSIONS/CLEARANCES/WEIGHTS
A Depth without Handles 33 3/4"
B Width 35 3/4"
C Height to Top of Case 68 3/8"
D Height to Top of Door Hinge 69 3/4"
E Back Clearance 2"
F Depth without Door 29 1/8"
G Depth (Total with Door Open) 48 1/4"
M Depth with Handles 36 1/4"
Width (Door Open 90˚ with Handle) 44 1/4"
Width (Door Open 90˚ without Handle) 39 1/4"
Door Edge Clearance with Handle 4 1/2"
Door Edge Clearance without Handle 1 1/3"
Installation Clearance Sides 1/8", Top 1", Back 2"
Carton Dimensions (WxHxD) 38" x 73" x 39"
PRODUCT DIMENSIONS
CLEARANCES
A
B
C
D
F
M
E
G
© 2018 LG Electronics USA, Inc. All rights reserved. "LG Life’s Good" is a registered trademark of LG Corp. All other product and brand names are trademarks or registered trademarks of their respective owners. Design, features and specifications are subject to
change without notice. Non-metric weights and measurements are approximate. Some features may require Internet access. Content and services may vary by product and are subject to change without notice. 5/17/18