MAXVIEW
®
Installation
1. Unpack magnifier and unfold the metal support brackets. The metal wire
brackets function as the mounting mechanism for the LCD Magnifier. The
top brackets (the longer ones) (A) are designed to hook over the top of the
monitor. The lower brackets (B) are designed to provide spacing and keep
the Magnifier parallel with the LCD screen. The lower brackets rest on the
front of the bezel.
2. Mount the LCD Magnifier onto the monitor. Swivel brackets from lens
so that they are perpendicular with the lens and Magnifier is parallel with
the LCD.
How to adjust the brackets: Turn and pull down
firmly on rubber washer to release it. Slide wire support to desired
position. Replace and tighten washer.
(A)
(B)
U.S. Patent #7,495,846
OCEANSIDE, NY 11572
3. The bracket height can be adjusted by pulling up
or down on the wire. Gently loosen the tightening knob
(Fig. 3), which will release the grip on the wire bracket.
After adjusting to the desired height, re-tighten the knob
to tightly grip the bracket. The lower brackets adjust
vertically in the same manner. These should be adjusted
to rest against the bottom section of the bezel. The top
bracket (A) and bottom brackets (B) are designed to
have vertical adjustability to permit optimum placement
of the magnifier in front of the monitor for best visual
performance.
4. To adjust magnification, swivel
brackets inwardly to change the
spacing from the magnifier to the
monitor. The greater the distance,
the larger the image will appear.
5. Cleaning The enclosed cleaning cloth is to be used for the front
surface. The rear (grooved) surface should be cleaned with forced air.
(A)
(B)
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Canon EOS 10D - Digital Camera SLR Owner's manual
-
-
Sony DI12023 User manual
-
Alvin Onyx User manual
-
-
-
Canon EOS-1D X Owner's manual
-
-
Canon EOS-1D Mark II N User guide
-