2. Allied Brass
  3. CV-1G-22-SBR

Allied Brass CV-1G-22-SBR Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Allied Brass CV-1G-22-SBR Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall
Determine your desired location for installation and make a mark for the location of the mounting plate and CARD-58 CAP.
Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting
plate over mark made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the
mark. (You may substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place
mounting plate over holes and secure to mounting surface using screws as shown below.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
CV-1G-22
MOUNTING PLATE
DRILLED HOLES
PERSPECTIVE
BACKPLATE
SET SCREW
MOUNTING PLATE
SCREW
WALL ANCHOR
DRILLED HOLE
DETAIL A
A
Step1: Attach Bracket to Mounting Plate
Place bracket on mounting plate and secure by tightening set screw as shown below.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
CV-1G-22
PERSPECTIVE
DETAIL B
BACKPLATE
SET SCREW
MOUNTING PLATE
B
/