① Wire Connector ②Base of the lamp
③Screws on the Main Body
④Outside Cover
⑤Main body ⑥Plastic expansion bolts
1.Remove the outside Cover
from the Main body of the wall
lamp.
2.Use the small Allen wrench to
remove the Base of the lamp from
the main body.
3.Drill two hole on the wall, and put
the 2 plastic expansion bolts into
these two holes, Then fix the base of
the lamp on the wall by using the 2
screws in the accessory package.
4.Fix the Main body of the lamp into
the base by using the Allen wrench.
Finally put the outside.
5.The wall lamp is successfully
installed.