37
Check that:
- the power of the installation is sufficient.
- the mains leads are in good condition.
- the diameter of the wires complies with the installation rules.
- your installation is fitted with 16 ampere heat protection.
If in doubt please consult your electrician.
The electrical connection must be carried out before placing the machine in its final position.
Electrical safety must be ensured by a correct connection. During maintenance operations the
machine must be unplugged from the mains and the fuses must be cut off or removed.
The machine must be connected with a standardised power cable with three 1.5 mm² conductors
(1 live + 1 neutral + 1 earth) which must be connected to the 220-240V 50Hz single phase mains
with a standardised electric socket CEI 60083 fitted with two pins and one earth in compliance
with the installation rules in force.
The Earth wire (green/yellow) is connected to the machine’s terminal and must be connected to
the earth of your electrical installation.
The Neutral wire (blue) must be connected to the mains neutral.
The Live wire (red, black, or brown) must be connected to the mains live.
The plug or any other electrical cut-off device must remain immediately accessible to allow an
emergency stop.
In your electrical installation also provide an accessible device which must be able to separate
the machine from the mains, the contact opening of which is at least 3 mm on all poles.
If the oven has any type of damage, unplug it or disconnect it from the mains.
If the mains lead on your machine is damaged it must be replaced by the manufacturer, its after-
sales service or any other similarly qualified person to avoid any danger.
Caution: We cannot be held liable in the event of an accident or incident resulting from non-
existent, defective or incorrect earthing.
See the instructions on « Materials you can use in microwave oven or to be avoided in
microwave oven.» There may be certain non-metallic utensils that are not safe to use for
microwaving. If in doubt, you can test the utensil in question following the procedure below.
Utensil Test:
1. Fill a microwave-safe container with 1 cup of cold water (250ml) along with the utensil in question.
2. Cook on maximum power for 1 minute.
3. Carefully feel the utensil. If the empty utensil is warm, do not use it for microwave cooking.
4. Do not exceed 1 minute cooking time.