BEGLEC EXERCET Owner's manual

Version: 1.0

WWW.BEGLEC.COM

Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited.

Operation Manual

Mode d'emploi

Gebruiksaanwijzing

Bedienungsanleitung

Manual de instrucciones

Manual do utilizador

EN

FR

NL

DU

ES

PT

DISPOSAL OF THE DEVICE

Dispose of the unit and used batteries in an environment friendly manner

according to your country regulations.

DÉCLASSER L’APPAREIL

Débarrassez-vous de l’appareil et des piles usagées de manière écologique

Conformément aux dispositions légales de votre pays.

VERWIJDEREN VAN HET APPARAAT

Verwijder het toestel en de gebruikte batterijen op een milieuvriendelijke

manier conform de in uw land geldende voorschriften.

ENTSORGUNG DES GERÄTS

Entsorgen Sie das Gerät und die Batterien auf umweltfreundliche Art und

Weise gemäß den Vorschriften Ihres Landes.

DESHACERSE DEL APARATO

Reciclar el aparato y pilas usadas de forma ecologica conforme a las

disposiciones legales de su pais.

ENGLISH OPERATION MANUAL

JB SYSTEMS® 1/30 TOMAHAWK+PATRIOT+EXERCET

Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own

safety, please read these operating instructions very carefully before you start using this unit.

FEATURES

This unit is radio-interference suppressed. This product meets the requirements of the current European

and national guidelines. Conformity has been established and the relevant statements and documents

have been deposited by the manufacturer.

• This device has been designed to produce decorative effect lighting and is used in light show systems.

• Sound activated, multicolored gobo flower

• 18 gobos, including 6 multicolor gobos

• Excellent optics for enhanced brightness

• 2 switches control gobo and reflector dish for

• continuous or sound activated rotation

• Sound activated by built-in microphone

• Tomahawk: equipped with an extra 90° sweeping scan mirror

• Patriot: equipped with an extra special quad angled 90° sweeping scan mirror

BEFORE USE

• Before you start using this unit, please check if there’s no transportation damage. Should there be any,

do not use the device and consult your dealer first.

• Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary

for the user to strictly follow the safety instructions and warnings in this user manual. Any damage

caused by mishandling are not subject to warranty. The dealer will not accept responsibility for any

resulting defects or problems caused by disregarding this user manual.

• Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user

manual.

Check the contents:

Check that the carton contains the following items:

• Operating instructions

• Light effect

• Hanging bracket

• 3 Knobs to fasten the hanging bracket

• Lamp

ENGLISH OPERATION MANUAL

JB SYSTEMS® 2/30 TOMAHAWK+PATRIOT+EXERCET

SAFETY INSTRUCTIONS:

• To protect the environment, please try to recycle the packing material as much as possible.

• A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and

disappears after some minutes.

• To prevent fire or shock hazard, do not expose this appliance to rain or moisture.

• To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures

when bringing it into a warm room after transport. Condense sometimes prevents the unit from working

at full performance or may even cause damages.

• This unit is for indoor use only.

• Don’t place metal objects or spill liquid inside the unit. Electric shock or malfunction may result. If a

foreign object enters the unit, immediately disconnect the mains power.

• Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. The

fixture must be fixed at least 50cm from surrounding walls.

• Don’t cover any ventilation openings as this may result in overheating.

• Prevent use in dusty environments and clean the unit regularly.

• Keep the unit away from children.

• Inexperienced persons should not operate this device.

• Maximum save ambient temperature is 45°C. Don’t use this unit at higher ambient temperatures.

• The units’ surface temperature may reach up to 85°C. Don’t touch the housing with bare hands during

its operation.

• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging

and servicing.

• Allow the device about 10 minutes to cool down before replacing the bulb or start servicing.

• Always unplug the unit when it is not used for a longer time or before replacing the bulb or start

servicing.

• The electrical installation should be carried out by qualified personal only, according to the regulations

for electrical and mechanical safety in your country.

• Check that the available voltage is not higher than the one stated on the rear panel of the unit.

• The power cord should always be in perfect condition: switch the unit immediately off when the power

cord is squashed or damaged.

• Never let the power-cord come into contact with other cables!

• This fixture must be earthed to in order comply with safety regulations.

• Don’t connect the unit to any dimmer pack.

• Always use an appropriate and certified safety cable when installing the unit.

• In order to prevent electric shock, do not open the cover. Apart from the lamp and mains fuse there are

no user serviceable parts inside.

• Never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same

type and electrical specifications!

• In the event of serious operating problems, stop using the fixture and contact your dealer immediately.

• The housing and the lenses must be replaced if they are visibly damaged.

• Please use the original packing when the device is to be transported.

• Due to safety reasons it is prohibited to make unauthorized modifications to the unit.

Important: Never look directly into the light source! Don’t use the effect in the presence of persons

suffering from epilepsy.

ENGLISH OPERATION MANUAL

JB SYSTEMS® 3/30 TOMAHAWK+PATRIOT+EXERCET

DESCRIPTION:

1. Optical lens

2. Hanging bracket with knob to fasten the unit and a mounting hole to fix a mounting hook.

3. Mains cable

4. Fuse ho lder

5. Lamp compartment

6. Switch for gobos: “0” = continuous rotation * “1” = sound activated rotation

7. Switch for inner reflector: “0” = continuous rotation * “1” = sound activated rotation

8. Tomahawk: equipped with an extra 90° sweeping scan mirror

Patriot: equipped with an extra special quad angled 90° sweeping scan mirror

Exercet: not available

LAMP (RE)PLACEMENT

In case of replacement of the lamp or maintenance, do not open the fixture within

10 minutes until the unit cools down after switching off. Always unplug the unit

before servicing! Always use the same type of spare parts (bulbs, fuses, etc.)

When replacing parts, please only genuine spare parts.

• Unplug the mains cable.

• Wait for about 10 minutes until the unit has been cooled

down.

• Unscrew the knobs that close the lamp compartment of

the fixture and open it.

• On the inside you will see the lamp socket. Tear the

lamp socket gently out of the lamp compartment.

• Unplug the old lamp. Hold the lamp socket while

unplugging the lamp instead of pulling the cable!

• Hold the lamp socket while pressing the new lamp

gently in the socket.

Attention! Check the label on the backside of the

device or see the technical specifications in this manual

to know which lamp should be used. Never install lamps

with a higher wattage! Lamps with higher wattage generate temperatures the device was not designed

for. If the device uses a lamp transformer, it will burn due to current overload.

• Don’t touch the bulb with bare hands! This drastically shortens the lifespan of the lamp. If you touched

the lamp, clean it with a cloth and a little denatured alcohol. Wipe the lamp off before installing.

• Put the new lamp back inside the unit. Be sure that the wires don’t touch the lamp.

• Close the lamp compartment with the screws.

• Done!

ENGLISH OPERATION MANUAL

JB SYSTEMS® 4/30 TOMAHAWK+PATRIOT+EXERCET

OVERHEAD RIGGING

• Important: The installation must be carried out by qualified service personal only. Improper

installation can result in serious injuries and/or damage to property. Overhead rigging requires

extensive experience! Working load limits should be respected, certified installation materials

should be used, the installed device should be inspected regularly for safety.

• Make sure the area below the installation place is free from unwanted persons during rigging, de-

rigging and servicing.

• Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The

fixture must be fixed at least 50cm from surrounding walls.

• The device should be installed out of reach of people and outside areas where persons may walk by or

be seated.

• Before rigging make sure that the installation area can hold a minimum point load of 10times the

device’s weight.

• Always use a certified safety cable that can hold 12times the weight of the device when installing the

unit. This secondary safety attachment should be installed in a way that no part of the installation can

drop more than 20cm if the main attachment fails.

• The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!

• Don’t cover any ventilation openings as this may result in overheating.

• The operator has to make sure that the safety-relating and machine-technical installations are approved

by an expert before using them for the first time. The installations should be inspected every year by a

skilled person to be sure that safety is still optimal.

OPERATING INSTRUCTIONS

• Once connected to the mains the device starts running.

• Use the switch for the gobos:

o “0” = continuous rotation

o “1” = sound activated rotation

• Use the switch for the inner reflector:

o “0” = continuous rotation

o “1” = sound activated rotation

The additional scan mirrors on Patriot and Tomahawk always work in sound activated mode.

• Regular breaks during operation are essential to maximize the life of this device as it is not designed for

continual use.

• Do not switch the unit on and off in short time intervals as this reduces the lamp life.

• The units’ surface temperature may reach up to 85°C. Don’t touch the housing with bare-hands during

its operation.

• Always unplug the unit when it is not used for a longer time or before replacing the bulb or start

servicing.

• In the event of serious operating problems, stop using the fixture and contact your dealer immediately.

• Important: Never look directly into the light source! Don’t use the effect in the presence of persons

suffering from epilepsy.

MAINTENANCE

• Make sure the area below the installation place is free from unwanted persons during servicing.

• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.

During inspection the following points should be checked:

• All screws used for installing the device and any of its parts should be tightly fastened and may not be

corroded.

• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any

deformation.

• When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.

• The mains cables must be in impeccable condition and should be replaced immediately when even a

small problem is detected.

ENGLISH OPERATION MANUAL

JB SYSTEMS® 5/30 TOMAHAWK+PATRIOT+EXERCET

• In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be

cleaned monthly.

• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.

• The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to

optimize light output. Cleaning frequency depends on the environment in which the fixture operates:

damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s

optics.

• Clean with a soft cloth using normal glass cleaning products.

• Always dry the parts carefully.

• Clean the external optics at least once every 30 days.

• Clean the internal optics at least every 90 days.

Attention:

We strongly recommend internal cleaning to be carried out by qualified personnel!

SPECIFICATIONS

Mains Input: AC 230V, 50Hz

Fuse: 250V 3A slow blow (20mm glass)

Sound Control: Internal microphone

Lamp: EFP 100W / 12V

Exercet:

Size: 24 x 20 x 12cm

Weight: 4.6kg

Patriot:

Size: 45 x 32 x 16cm

Weight: 5.1kg

Tomahawk:

Size: 38 x 21 x 12cm

Weight: 5.0kg

Every information is subject to change without prior notice

FRANÇAIS MODE D’EMPLOI

JB SYSTEMS® 6/30 TOMAHAWK+PATRIOT+EXERCET

Merci d’avoir choisi ce produit JB Systems. Pour votre sécurité et pour une utilisation optimale de toutes

les possibilités de l’appareil, lisez attentivement cette notice avant utilisation.

CARACTERISTIQUES

Cet appareil ne produit pas d’interférences radio. Il répond aux exigences nationales et européennes. La

conformité a été établie et les déclarations et documents correspondants ont été déposés par le fabricant.

• Cet appareil a été conçu pour la production d’effets lumière décoratifs et est utilisé dans des spectacles

lumineux.

• Gobo flower coloré piloté par la musique

• 18 gobos dont 6 gobos multicolores

• Optique étudiée pour une clarté optimale

• 2 intérupteurs contrôlent les gobos et le réflecteur, pour une rotation au rythme de la musique ou

continue

• Micro incorporé

• Tomahawk: équipé d’un miroir scan pivotant a 90°

• Patriot: équipé d’un miroir spécial quadrilatère pivotant a 90°

AVANT UTILISATION

• Avant d’utiliser cet appareil, assurez-vous de l’absence de dommage lié au transport. En cas

d’endommagement, n’utilisez pas l’appareil et contactez le vendeur.

• Important: Cet appareil a quitté notre usine en parfaite condition et bien emballé. Il est primordial que

l’utilisateur suive les instructions de sécurité et avertissements inclus dans ce manuel. La garantie ne

s’applique pas en cas de dommage lié à une utilisation incorrecte. Le vendeur ne prend pas la

responsabilité des défauts ou de tout problème résultant du fait de n’avoir pas tenu compte des mises

en garde de ce manuel.

• Conservez ce manuel dans un endroit sûr pour toute consultation future. Si vous vendez l’appareil,

assurez-vous d’y joindre ce manuel également.

Vérifiez le contenu:

Vérifiez si l’emballage contient les articles suivants:

• Mode d'emploi

• L’appareil

• Support de fixation

• 3 leviers de serrage

• Lampe

Page is loading ...

BEGLEC EXERCET Owner's manual

This manual is also suitable for

BEGLEC EXERCET Owner's manual

in other languages

Related papers

Other documents