USER’S MANUAL
MAN193_0
www.moosesound.com
PROUDLY DEVELOPED AND
MANUFACTURED IN PORTUGAL
Public address amplifier
Mixer-amplifier
TL120D & TL200D
PUBLIC
PUBLIC
ADDRESS
ADDRESS
A
A
M
M
P
P
L
L
I
I
F
F
I
I
E
E
R
R
D
D
I
I
N
N
G
G
D
D
O
O
N
N
G
G
T
T
R
R
E
E
B
B
L
L
E
E
BASS
BASS
MASTER VOLUME
MASTER VOLUME
-13
-13
-8
-8
-3
-3
0dB
0dB
CLIP
CLIP
VOLUME
VOLUME
OUPUT LEVEL
OUPUT LEVEL
POWER ON
POWER ON
0
0
10
10
MIC
MIC
MIC/LINE
MIC/LINE
VOLUME
VOLUME
EQUALIZER
EQUALIZER
TL120D
TL200D
1
1
2
2
3
3
4
4
Dear customer,
Thank for choosing MOOSE branded products!
MOOSE is a brand of professional audio & lighting products, proudly developed and manufactured in
PORTUGAL.
In order to operate this product in a safe and reliable manner, please follow the instructions in this booklet and
before operating the equipment read the instructions carefully and please note the technical information.
Our products undergo very rigorous testing under strict conditions and they are monitored continuosly during the
manufacturing process. In order to guarantee the product function and safety, the original parts of the
manufacturer's design must be used. If any parts other than those of the manufacturer are used, or the product is
modified in any way, the user forfeits all warranty rights to claim.
MAN193_0
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
To prevent electrical shock do not remove
the cover. No user serviceable parts inside.
Refer service to qualified personnel only.
Introduction
www.moosesound.com 2
Caution
The lightning flash with arrowhead symbol within an equilateral triangle is intended
to alert the user to the presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude to constitute a risk of
electrical shock.
The exclamation mark within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance instructions.
The amplifier is marked with this instruction so please
proceed accordingly in order to avoid any hazard.
1. Before connecting the equipment to the power outlet, first verify that the mains voltage and frequency match
the values specified on the equipment.
2. If the power cord of the device is equipped with an earthing contact, then it must be connected to an outlet
with a protective ground. Never deactivate the protective ground of a power cord.
3. Unplug the power cord and power adapter from the power outlet if there is a risk of a lightning strike or before
extended periods of disuse.
4. Replace fuses only with fuses of the same type and rating. If a fuse blows repeatedly, please contact an
authorised service company.
5. Do not open or modify this equipment.
6. After connecting the equipment, check all cables in order to prevent damage or accidents, e.g., due to tripping
hazards.
7. Do not turn on the Amplifier ON before checking that all volumes to zero .
IMPORTANT: Never remove the cover, because otherwise there may be a risk of electric shock. There are no user
serviceable parts inside. Have repairs carried out only by qualified service personnel.
PA mixer-amplifier
TL120D & TL200D
www.moosesound.com 3
Manufacturers Declaration
PROPER DISPOSAL OF THIS PRODUCT
(Valid in the European Union and other European countries with waste separation)
This symbol on the product, or the documents accompanying the product, indicates that this appliance may not
be treated as household waste. This is to avoid environmental damage or personal injury due to uncontrolled
waste disposal. Please dispose of this product separately from other waste and have it recycled to promote
sustainable economic activity.
Household users should contact either the retailer where they purchased this product, or their local government
office, for details on where and how they can recycle this item in an environmentally friendly manner.
Business users should contact their supplier and check the terms and conditions of the purchase contract. This
product should not be mixed with other commercial wastes for disposal .
ENVIRONMENTAL PROTECTION AND ENERGY CONSERVATION
Energy conservation is an active contribution to environmental protection. Please turn off all unneeded electrical
devices. To prevent unneeded devices from consuming power in standby mode, disconnect the mains plug.
EC DECLARATION OF CONFORMITY
The equipment marketed by MOOSE complies (where applicable) with the essential requirements and other
relevant specifications of Directives 1999/5/EC (R&TTE), 2004/108/EC (EMC) und 2006/95/EC (LVD). Additional
information can be requested to info@profactor.pt.
PROUDLY DEVELOPED AND MANUFACTURED IN PORTUGAL
MAN193_0
PA mixer-amplifier
TL120D & TL200D
www.moosesound.com 4
Connections and Controls
Please refer to the following scheme and instructions:
MAN193_0
1. POWER ON: Illuminated on/off switch. Before switching the system on, always adjust the volume to zero.
2. VOLUME 1: Channel 1 Volume Control.
3. VOLUME 2: Channel 2 Volume Control.
4. VOLUME 3: Channel 3 Volume Control.
5. VOLUME 4: Channel 4 Volume Control.
6. TREBLE: Master tone equalizer control - Treble.
7. BASS: Master tone equalizer control - Bass.
8. MASTER: Master Volume Control;
9. DING DONG: This Trimmer allows you control Ding Dong´s volume.
10. OUTPUT: 100V Line transformer terminal output for Speakers - respect polarity.
11. OUTPUT: Low impedance (4-16ohm) terminal output for Speakers - respect polarity.
12. MIC1: Channel 1 microphone input socket - Jack ¼’’.
13. MIC2: Channel 2 microphone input socket - Jack ¼’’.
14. MIC3: Channel 3 microphone input socket - Jack ¼’’.
15. MIC4: Channel 4 microphone input socket - Jack ¼’’.
16. MIC3 / LINE3: This switch allows you to choose between MIC3 or LINE3 Input. You can adjust Volume with
VOLUME3 Pot ( 4 ).
Main volume adjustment. Sets the relative level of input signal.
PA mixer-amplifier
TL120D & TL200D
PUBLIC ADDRESS AMPLIFIER
DING
DONG
TREBLE
BASS MASTER VOLUME
-13 -8 -3 0dB CLIP
VOLUME
OUPUT LEVEL
POWER ON
0 10
MIC MIC/LINE
VOLUME EQUALIZER
TL120D
1 2 3 4
2
4
5
6
7
8
1
9
3
SLAVE
REC
MAINS
230V AC
50HZ / 150VA
FUSE F 6A
1PRIORITY MIC 2 3 4
MIC
LINE
MICLINE
PHANTOM
OFFON
MICLINE
MIC INPUT
DING DONG
1
2
3
45
(OPTIONAL)
INPUT
CAUTION
RISK OF EL ECTRI C SHOCK. DO NOT OP EN.
To prev ent elec trica l shock d o not remo ve
the cov er. No user s ervice able par ts insi de.
Refe r ser vice to q ualif ied pe rsonn el only.
PROUDLY DEVELOPED AND
MANUFACTURED IN PORTUGAL
0-100V
OUTPUT
4/16
24
10
11
23
15
16
18
19
21
14
17
20
12
13
22
www.moosesound.com 5
Connection diagram
MAN193_0
PA mixer-amplifier
TL120D & TL200D
4 - 16ohm
100V
YOU GET MAXIMUM OUTPUT POWER WITH 4Ohm
100V
100V
100V
100V
8Ohm
8Ohm
8Ohm
8Ohm
S SPEAKER´S POWER = AMPLIFIER RATED POWER
In order to ensure the right procedure, please folow as described:
1 - Verify that all Volume Control Pots ( 2 - 5 / 8 ) are at their minimum value ( 0 );
2 - Connect the Mains Supply Cable ( 24 );
3 - Connect all Microphones and Devices that will be working with TL120D/TL200D to their respective Inputs
just like next page´s picture;
4 - Connect the Speakers. If you have Low Impedance Speakers then you must connect them to Terminals ( 11 ).
In case your Speakers have 100V Line Transformer then you must connect them to Terminals ( 10 ), always
respecting polarity;
5 - Connect the Amplifier applying on the On/Off Power Switch ( 1 );
6 - Adjust Volumes and Equalization;
Your Amplifier is ready to start working. If something wrong occurs you must turn off the Amplifier and verify all
connections and steps again.
17. LINE 3: Signal Input to connect a CD Player or an AM/FM Transmitter ( Radio ).
18. LINE 4: Signal Input to connect a CD Player or an AM/FM Transmitter ( Radio ).
19. MIC4 / LINE4: This switch allows you to choose between MIC4 or LINE4 Input. You can adjust volume through
front panel volume pot ( 5 ).
20. SLAVE:
21.
22. PHANTOM: This switch allows you to connect/disconnect Phantom Power supply.
23. PRIORITY MIC: Input Socket for connection of a Priority Mic.
Signal output in RCA for connection of another device such as an amplifier.
REC: Signal output in RCA for connections of a recorder device.
24. MAINS IN: Power socket with fuse holder, AC 230V - 50~60Hz. Replace the fuse only with a fuse of the same
type and rating. If the fuse blows repeatedly, please contact an authorised service company.
Connections and Controls
PRIORI T Y
MIC
MIC1
MIC2
RECORDE R
AMPLIF I E R
CD
CD
LINE 3
LINE 4
MIC 4
MIC 3
SLAVE
REC
MAINS
230V AC
50HZ / 150VA
FUSE F 6A
1PRIORITY MIC 2 3 4
MIC
LINE
MICLINE
PHANTOM
OFFON
MICLINE
MIC INPUT
DING DONG
1
2
3
45
(OPTIONAL)
INPUT
CAUTION
RISK OF ELE CTRIC SH OCK. DO NOT OPE N.
To preve nt elect rical s hock do n ot remove
the cove r. No user se rvicea ble par ts insid e.
Refer servi ce to qu alifi ed per sonne l only.
PROUDLY DEVELOPED AND
MANUFACTURED IN PORTUGAL
0-100V
0-100V
0-100V
OUTPUT
OUTPUT
OUTPUT
4/16
4/16
4/16
www.moosesound.com 6
MAN193_0
PA mixer-amplifier
TL120D & TL200D
Dimensions
Unit: mm (milimeters)
Technical specifications
MODEL TL120D TL200D
TYPE Public address mixer-amplifier Public address mixer-amplifier
POWER OUTPUT (RMS) 120W 200W
FREQUENCY RANGE 50Hz - 14kHz 50Hz - 14kHz
T.H.D. (20Hz - 20kHz) < 1% @ 1kHz < 1% @ 1kHz
S/N RATIO > 90dB @ 1kHz > 90dB @ 1kHz
ZONES No No
CONTROLS Bass, Treble, Master, volume for MIC and LINE in
INDICATORS Power on, Signal and Clip Power on, Signal and Clip
INPUTS Microphone and Line Microphone and Line
OUTPUTS
CONNECTORS
PHANTOM POWER
OTHER FEATURES
PROTECTIONS
OPERATING VOLTAGE
POWER CONSUMPTION
COOLING
4-16ohm, 100V 4-16ohm, 100V
Input in 6.3mm Jack, Link in RCA & Output: touch-proof binding post, REC in RCA
+48V DC +48V DC
Ding-dong, priority MIC, MIC/LINE switch
Short circuit, thermal overload Short circuit, thermal overload
230V AC (factory config.), 50~60Hz
150VA 220VA
Continuously speed fan, 80mm / 230V AC
DIMENSIONS (WxDxH) 2RU space, 345mm depth 2RU space, 345mm depth
WEIGHT 7Kg 9Kg
484
484
430
430
88
88
PUBLIC
PUBLIC
ADDRESS
ADDRESS
A
A
M
M
P
P
L
L
I
I
F
F
I
I
E
E
R
R
D
D
I
I
N
N
G
G
D
D
O
O
N
N
G
G
T
T
R
R
E
E
B
B
L
L
E
E
BASS
BASS
MASTER VOLUME
MASTER VOLUME
-13
-13
-8
-8
-3
-3
0dB
0dB
CLIP
CLIP
VOLUME
VOLUME
OUPUT LEVEL
OUPUT LEVEL
POWER ON
POWER ON
0
0
10
10
MIC
MIC
MIC/LINE
MIC/LINE
VOLUME
VOLUME
EQUALIZER
EQUALIZER
TL120D
TL200D
1
1
2
2
3
3
4
4
SLAVE
SLAVE
REC
REC
MAINS
MAINS
230V AC
230V AC
50HZ / 150VA
50HZ / 150VA
FUSE F 6A
FUSE F 6A
1
1
PRIORITY MIC
PRIORITY MIC
2
2
3
3
4
4
MIC
MIC
LINE
LINE
MIC
MIC
LINE
LINE
PHANTOM
PHANTOM
OFF
OFF
ON
ON
MIC
MIC
LINE
LINE
MIC INPUT
MIC INPUT
DING DONG
DING DONG
1
1
2
2
3
3
4
4
5
5
(OPTIONAL)
(OPTIONAL)
INPUT
INPUT
CAUTION
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
To prevent electrical shock do not remove
To prevent electrical shock do not remove
the cover. No user ser viceable par ts inside.
the cover. No user ser viceable par ts inside.
Refer ser vice to qualifie d personnel only.
Refer ser vice to qualifie d personnel only.
PROUDLY DEVELOPED AND
MANUFACTURED IN PORTUGAL
PROUDLY DEVELOPED AND
MANUFACTURED IN PORTUGAL
0-100V
0-100V
OUTPUT
OUTPUT
4/16
4/16
www.moosesound.com
PROUDLY DEVELOPED AND
MANUFACTURED IN PORTUGAL
PROFACTOR S.A
Rua do Padrão 52
4440-617 Valongo
PORTUGAL
Telf.: +351 224 119 160
Fax: +351 224 155 822
info@profactor.pt
MOOSE is a brand or PROFACTOR S.A.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
