Buffalo HBJ12 Owner's manual

Brand: Buffalo

Model: HBJ12

Type: Owner's manual

Buffalo HBJ12 is a 12-ton hydraulic jack designed for lifting heavy loads. With a minimum height of 8.5 inches and a maximum height of 13.75 inches, it can be used in a variety of applications, including automotive repair, construction, and industrial settings. The jack features a release valve lever for easy lowering of the load, and a pump handle for lifting. It also comes with an extension screw for added height, and a rubber plug for easy oil filling. The Buffalo HBJ12 is a versatile and powerful tool that can be used for a variety of lifting tasks.

READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.

This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this

manual. These instructions are not meant to cover every possible condition and situation that may occur.

We reserve the right to

change this product at any time without prior notice.

IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO

NOT OPERATE THIS PRODUCT!

HAVE QUESTIONS OR PROBLEMS? DO NOT RETURN THIS PRODUCT TO THE

RETAILER - CONTACT CUSTOMER SERVICE.

If you experience a problem or need parts for this product, visit our website

http://www.buffalotools.com

or call our customer help line at 1-888-287-6981

, Monday-Friday, 8 AM - 4 PM Central Time. A copy

of the sales receipt is required.

FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE.

201004

HBJ12

INSTRUCTION MANUAL

12 TON MULTI-PURPOSE

HYDRAULIC JACK

HBJ12 12 Ton Multi-Purpose Hydraulic Jack

12 Ton Multi-Purpose Hydraulic Jack HBJ12 Assembly & Operating Instructions

Verify that you have received the parts in the correct quantities as shown below.

1. Before operating, estimate the weight of the load. DO NOT OVERLOAD the jack beyond its

rated load.

2. Select point of action according to the gravitational center. Place the jack on a hard, flat

surface.

3. Insert the notched end of the handle into the release valve. Turn the operating handle clock-

wise until release valve is closed. Do not overtighten the valve.

4. Insert pump handle into the socket and pump up and down slowly. The ram will raise and

then stop when the required height is reached.

5. Lower the ram by slowly turning the release valve counter clockwise.

To Add or Replace Oil: Push RAM down fully. Remove rubber plug from reservoir and fill oil to

plug position. Use motor oil S.A.E. 10W.

WARNING Use jack for lifting only. Never exceed this jack’s rated load capacity. Never

work under the lift load without additional support devices.

Pump Handle

Hydraulic Jack

Parts List

Description Qty

Hydraulic Jack

Pump Handle

Item No.

1. Release Valve Lever

2. Base

3. O-Ring

4. Hydraulic Cylinder

5. Ram

6. Hydraulic Oil

7. Oil Tight Tank

8. Extension Screw

9. Top Cap

10. Pump Plunger

11. Pump Body

12. O-Ring

Minimum Height = 8.5"

Maximum Height = 13.75"

Buffalo HBJ12 Owner's manual

Buffalo HBJ12 Owner's manual

Buffalo HBJ12 Owner's manual

Related papers

Other documents