9417 WALL MOUNTING INSTALLATION GUIDE
Use these instructions and the template to mount your 9417 printer on the wall.
Using the Template
1. Select a suitable location for the printer
on a wall.
2. Tape the wall mount template to the
wall in the selected location.
Note: The template must be level or the
printer will not install correctly.
3. Install four wall anchors (not included,
see below) according to the four
outside holes indicated on the template.
4. Remove the template.
5. Lower the front cover on the printer so
you can see the mounting holes on the
back of the printer.
6. Attach the printer to the wall anchors
using the corresponding holes on the
back of the printer.
7. Press down firmly on the printer to lock
it in place.
Mounting holes in back of printer
8. Close t
he cover.
Wall Mounting Hardware
Wall mounting hardware is not included. You must use hardware designed for your type of
installation.
Bolt shaft diameter can be no larger than 5mm.
Bolt head diameter must be between 5mm - 11.9mm.
Hardware must be rated to support the weight of your printer. Maximum printer weight is
approximately 15.5 lbs (dual printer model with two new rolls of supply).
Avery Dennison®, Monarch®, and Freshmarx® are registered trademarks of Avery Dennison Corporation.
TC9417IG Rev. AA 4/13 ©2013 Avery Dennison Corp. All Rights Reserved.
10
140
10
78
220
Ø
11.98
Ø
.005
TC9417IG_Template
NOTES:
1. Print template on 17” x 11” paper.
2. Do not resize; template is to scale.
3. Measurements are in Millimeters.
4. Use this template with manual TC9417IG.
-
1
-
2
Avery Dennison 9417+ Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Avery Monarch 9415 User manual
-
Avery Dennison FRESHMARX 9415 User guide
-
Avery Dennison SNAP 700 Owner's manual
-
-
Avery Dennison ADTP2 Reference guide
-
Avery Dennison 6140 Owner's manual
-
-
-
-