2. Topeak
  3. TC9629
TC9629

Topeak TC9629 Owner's manual

  • Hello! I've reviewed the user's guide for the Topeak R1 and R2 bicycle fenders. These fenders are designed for road bikes and provide detailed instructions on installation and angle adjustment. I am here to answer your questions regarding the installation process, compatible tire sizes, and the proper use of the included brake nut adaptors. How can I assist you today?
  • What tool is required for installation?
    What tire sizes are compatible with DeFender R1/R2?
    What should I do if my front brake uses an external brake nut?
    How should I adjust the fenders?
    How much of the rubber strap should I leave after install?
INSTALLATION & ANGLE ADJUSTMENT
Loosely affix rubber straps around
fork legs. Loosen plastic fender screws to adjust
supports.
Install DeFender R1 on fork and
tighten screw.
Loosen the screw.
(Do not remove completely)
DeFender R1 fits most standard road
bike fork crowns. If the front brake is
installed with an external brake nut,
replace the Internal Brake Nut Adaptor
(a) with the External Brake Nut
Adaptor (b) when installing your
Defender R1.
Tighten the rubber straps firmly.
Important Note:
Prepare to Ride
GB
DeFender R1 / R2
User's Guide
DeFender R1
Tool required: Phillips screw-driver #1
(Front)
(Rear)
b. External Brake
Nut Adaptor
(included)
a. Internal Brake Nut Adaptor
(pre-assemble)
External Brake Nut
Adjust DeFender R1 for proper
angle and tire clearance.
Re-tighten screws once
correct position is
reached.
for Road Bike only
700 x 20C to 700 x 25C
ROAD TIRE FITTING SIZE
Screws x 4
(included)
Leave approximately 12mm
of rubber strap, trim excess.
User's Guide
Prepare to Ride
M-TC9629-GB 02/08
WARRANTY
Topeak products are available only from professional bicycle shops.
Please contact your nearest Topeak authorized bicycle dealer for any questions.
For customers in the USA, call: 1-800-250-3068, Website: www.topeak.com
2-year Warranty: All mechanical components against manufacturer defects only.
Warranty Claim Requirements
To obtain warranty service, you must have your original sales receipt. Items returned without
a sales receipt will assume that the warranty begins on the date of manufacture.
All warranties will be void if the product is damaged due to user crash, abuse, system alteration,
modification, or used in any way not intended as described in this operating manual.
* The specifications and design are subject to change without notice.
Copyright © Topeak, Inc. 2008
INSTALLATION & ANGLE ADJUSTMENT
Tighten the rubber straps firmly.
Remove rear wheel carefully. Re-install rear wheel and loosely affix rubber
straps around seat stays.
DeFender R2
(Front)
(Rear)
Tool required: Phillips screw-driver #1
WARNING
Adjust DeFender R1/R2 for
correct angle and tire
clearance. Improper angle or
tire clearance may cause
damage to DeFender R1/R2 or
your bike and may cause
bodily harm.
About Angle Adjustment
"Click"
Install DeFender R2 clip around brake bolt.
Loosen plastic fender screws to adjust supports. Adjust DeFender R2 for proper angle and
tire clearance.
Re-tighten screws once
correct position is
reached.
DeFender R1 / R2
for Road Bike only
700 x 20C to 700 x 25C
ROAD TIRE FITTING SIZE
Trim excess strap material.
Leave approximately 12mm
of rubber strap, trim excess.
Screws x 4
(included)
/