ROCA
SPECIFICATIONS
Recommended use Domestic, Hotel & Commercial
Material Pan: Vitreous China
Seat: Urea
Colour White
Rim configuration Box Rim
Bowl configuration P Tap (Converts to S using plastic S-bend
provided)
Pan fixing Screwed to the floor using brackets
(supplied) and bedded with sealant
Seat Soft Close Seat
Inlet valve Recommended maximum working pressure
1000 KPa
Weight 28 Kg
CLEANING RECOMMENDATIONS
To see the complete ROCA range go to
www.reece.com.au/bathrooms
DAMA-N BTW PAN
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Conditions.
Dimensions are nominal measurements only.
Disclaimer: Products in this specification manual must by regulation be installed by licensed and
registered trade people. The manufacturer/distributor reserves the right to vary specifications or
delete models from their range without prior notification. Dimensions are nominal measurements only.
Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor
takes no responsibility for printing errors.
Tech Page Version 1
160
430
360
520
355
250
180
395
130
95
35
18
ø55
ø102 400 435
75
TM
AS 1172.1
page 1 of 5
The more
stars the more
water efficient
WATER R ATING
www.waterrating.gov.au
In accordance with AS/NZS 6400
Licence No. 0137
Bathroom Products Australia
4.5 L per full flush / 3 L per half flush
3.3litres
average flush