Coopers 9222 Operating instructions

Brand: Coopers

Model: 9222

Type: Operating instructions

Please read carefully before use and retain for future reference.

PARTS

Base x1

Lower handle section x1

Upper handle section x1

Hand grip x1

Microfibre pad x2

Polishing pad x2

Cleaning pad x2

Cloth bonnet x2

ASSEMBLY

• Attach the lower handle

section to the base using

the pre-fitted screw.

• Attach the upper handle

section to the lower handle

section ensuring the locking

pin clicks securely into

position.

• Attach the hand grip to the

upper handle section using

the pre-fitted screw.

• Ensure all fixings are tightened fully before use.

OPERATION

• Choose the desired pads and attach ensuring the plastic clips are secure.

• Apply a small amount of a suitable floor/carpet stain remover to stubborn stains to assist

removal.

• Press down on the on right side of the base unit and release the handle by pulling towards

you. This will activate the scrubbing brushes.

• When finished, raise the handle and lock into the upright position.

See table below for recommendations on when to use each set of cleaning pads:

Use

Microfibre pad

For use on hard floors

Polishing pad

For use on wooden floors

Cleaning pad

Use on stubborn stains

Scrubbing brushes (without

pads)

Use on carpets to agitate stains

Cloth bonnet

Attach

over

the polishing pad for use on large stain

and high

footfall areas on carpets.

Floor Polisher

9222

CLEANING

• Wipe base clean with a soft dry cloth.

• To clean pads, rinse in cold water.

• To clean scrubbing brushes, brush with a stiff brush.

WARNING

• Never carry the machine by the cord, or pull on the cord to disconnect the machine from a

socket; instead grasp the plug, and pull to disconnect.

• Keep cord away from heated surfaces. Do not pull cord around sharp edges or corners. Do

not close doors on the cord.

• Do not touch moving parts.

• For indoor use only.

• Do not leave appliance unattended, when plugged in.

• Unplug from outlet when not in use, and before removing cleaning or changing cleaning

pads or when the thermal cut out cuts in.

• Do not handle plug or appliance with wet hands.

• Do not allow product to be used by children.

• Keep away from children when in use.

• Check polisher and power cord for damage before use. Do not use if damaged.

• Do not use with or near flammable liquids.

• Do not store appliance near hot ovens or heating appliances.

• Use only manufacture’s recommended attachments.

• Make sure the appliance is connected to the correct voltage.

• No user serviceable parts.

• Do not submerge the appliance in water or other liquid. Do not place or store the appliance

where it can fall or be pulled into a vessel containing liquid.

• Do not use on wet floors or wet stains. Allow mopped floors or wet stains to dry before

polishing.

• This machine is equipped with a thermal cut out, to protect the motor from overheating.

The item will cut out if it gets too hot. If the appliance is left plugged in, it could start

unexpectedly when the motor cools.

PACKAGING

• Dispose of packaging at your local recycling centre.

• Dispose of paper and carton separately from plastic bags at your local recycling centre.

• Dispose of item at the end of its lifespan at your local authorised household waste recycling

centre.

Coopers 9222 Operating instructions

Coopers 9222 Operating instructions

Coopers 9222 Operating instructions

Other documents