Page is loading ...
1
91712
S e r v i c e P u l l o u t
I n s t a l l a t i o n
Service Pullout
Rev. __ Date:
TOOLS REQUIRED
(1) 7/16” Socket wrench (not supplied)
(1) 3/8” Socket wrench (not supplied)
(1) 5/32” Allen wrench (supplied)
(1) Level (not supplied)
(1) Rubber mallet
IMPORTANT! The LMS Full Frame must be level
before installing the Service Pullout.
1. Determine the desired height of the Service Pullout
and then insert the hooks* on the back of the unit into
the slotted standards and push down. See figure 2a.
To ensure that the hooks are seated, tap the top rear
corners with a rubber mallet.
The Service Pullout can be installed at four different
heights at one inch increments. The minimum height is
34”, the maximum height is 43”. See figure 1.
POSITIONING THE SERVICE PULLOUT
Figure 1
43” Maximum
34” Minimum
Service Pullout
LMS Full Frame
ITEM NUMBERS
ALLEPSD2430
ALLEPSD3030
ALPEPSD2430
ALPEPSD3030
*NOTE: It is suggested that the hooks be bent out
slightly to ease insertion into the slotted standards.
See figure 2b.
Figure 2a
Hooks
Slotted standards
Hook Plates
Figure 2a
Hook
Bend out slightly
2
S e r v i c e P u l l o u t
I n s t a l l a t i o n
91712
NOTE: The Service Pullout is shipped with the Front
Legs in their uppermost position.
LEVELING THE SERVICE PULLOUT
1. Pull the Drawer out. See figure 4.
2. Remove the three 1/4”-20 x 1/2” button head cap
screws that secure each Front Leg.
Do not discard.
3. Drop the Front Legs down until the levelers touch the
floor. Move each leg up until the threaded holes in
the legs align with the nearest holes in the Front
Channels. Re-install the 1/4”-20 x 1/2” button head
cap screws and tighten securely.
4. Turn the levelers counter clockwise until they touch
the floor. Adjust the levelers to level the unit.
Figure 4
Drawer
Figure 3
1/4-20 x 1/2” hex
washer head screws
Hook Plate
1. Pull the top surface of the unit out to gain access to
the inside of the unit. Locate the two holes at the rear
corners of the Service Pullout and using a 3/8” socket
wrench, thread a 1/4”-20 x 1/2” hex washer head
screw into each hole. Tighten each screw securely .
See figure 3.
SECURING THE UNIT TO THE FRAME
IMPORTANT!
Top surface
Service Pullout
Leveler
1/4”-20 x 1/2” button
head screws
Leg
Leg
Leveler
Leg Channel
3
S e r v i c e P u l l o u t
I n s t a l l a t i o n
91712
GLASS INSTALLATION
1. Carefully unpack the Glass Panel (located under the
drawer) and position it on the flange at the bottom of
the opening in the Drawer front. See figure 5.
Drawer front
Glass Panel
Flange
Figure 5
Figure 6
Service Pullout
2. Hold the Glass Panel in place and install the two
Glass Retainers onto the threaded studs located on
both sides of the Drawer front. See figure 6. Slide
the retainers against the Glass Panel and secure them
using the four 1/4”-20 Kep nuts provided.
1/4”-20 Kep nuts
Glass Panel
Glass Retainers
Threaded studs
/
