EDWARDS 111 Series Installation guide

WIRING DIAGRAM:

P/N 3100464 ISSUE 1

WHITE

WIRES

BLACK

WIRES

POWER

WARNING:

TURN OFF ELECTRICITY, remove fuse or switch off circuit

breaker.

THERE IS A RISK OF FIRE AND ELECTRICAL SHOCK.

FIXTURE SHOULD BE INSTALLED BY A QUALIFIED

ELECTRICIAN IN ACCORDANCE WITH NATIONAL & LOCAL

ELECTRICAL CODES.

FIXTURE INSTALLATION:

1. Make sure electricity is turned OFF.

2. Put weatherproof gasket in position under cover.

3. Connect wires as shown in diagram.

4. Attach fixture to junction box with (4) screws supplied.

5. Install lamp glass globe, and aluminum guard. Tighten set

screw.

6. Turn on power.

LAMP INSTALLATION

OR RELAMPING:

1. Use 150 watt incandescent lamp Maximum. See socket for

proper selection.

2. Disconnect power and let lamp cool if it was in operation.

3. Loosen set screw and unscrew aluminum guard and glass.

4. Replace lamp.

5. Replace glass globe and aluminum guard, reconnect power.

CHESHIRE, CT 203-699-3300

FAX 203-699-3365 (CUST. SERV.)

203-699-3078 (TECH. SERV.)