2. FMI
  3. GA3555

FMI GA3555 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the FMI GA3555 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
NOTICE: A qualied electrician must connect electrical wiring to duplex outlet for built-in
installation. Follow all local codes.
Figure 1 - Installing Duplex Outlet
Cable from
Electrical
Source
Duplex Outlet
Screw
Blower
Power
Cord
Blower
Support Bracket
GA3555 Outlet Kit instAllAtiOn instructiOns
FOr use with iV33 series FireplAce inserts, VyGF33, VsGF28, VsGF33 And
cGeFp33 series Vent-Free FireplAce systems
IMPORTANT: Read entire instruction sheet
before installing GA3555 Outlet.
This outlet kit contains the following:
Qty. Part No. Description
1 103706-01 4" x 5
1
/
4
" Silver Shield
2 11164 Black Screws, #8 x 3/8"
1 11193 Screw, #6-32 x 1/2"
1 14418 Duplex Receptacle
1 14123 Strain Relief Fitting
**Not sold separately
If any of these parts are missing or damaged,
call FMI PRODUCTS, LLC at 1-866-328-4537.
1. Install blower assembly per instruction sheet
included.
2. Beforereplacingbottomofrebox,install
duplex outlet to the right support bracket in
thebottomofrebox(seeFigure1).
3. Route wires from electrical box through
smallest hole in outer casing using strain
reliefttingprovided(seeFigure1).
4. Connect wires from the electrical box to
duplex outlet. Match wire colors to those
indicated on duplex outlet. Be sure to con-
nect ground wire.
5. Install shield to end of right support bracket
andbehindthereboxwrapperwith2
screwsprovided(seeFigure2).
6. Plug blower power cord into duplex outlet.
Note: Onthermostatmodelreplaces,route
powercordtothebackofthereplaceto
clearthermostatvalve(seeFigure2).
7. Replacebottomofrebox.
Figure 2 - Installing Shield
Shield
Screws
103707-01
Rev. E
07/09
Support Bracket
Firebox
Wrapper
Power
Cord
Strain Relief
Fitting
Manufactured by
FMI PRODUCTS, LLC
2701 S. Harbor Blvd.
Santa Ana, CA 92704
www.fmiproducts.com
/