Barco RHDM-1701B Quick start guide

Brand: Barco

Model: RHDM-1701B

Type: Quick start guide

This manual is also suitable for

RHDM-1701P

Barco n.v.

President Kennedypark 35

B-8500 Kortrijk, Belgium

www.barco.com

Quick Installation Sheet RHDM

1701

Power up

Start

up and setup the display unit

Connect signal on SDI input board and display it on the screen

• If the display unit does not show an image on the screen and the  button lights up orange, then the display unit is in standby.

Press the  button to activate the display unit. If the  button lights up green, the display unit is active.

• The “Invalid input” icon should appear on the screen when no valid signals are available.

• Connect the power cable from the mains 100-240 Vac to the power connector

• Switch on the power switch at the back of the display unit

• Connect an SDI or HDSDI signal to the input connector

• Press button  to activate window 1

• Assign the input signal to window 1 by pressing the  button until the input signal is shown on the screen.

• Similarly as for button , button 

acts for window 2.

“Invalid input” icon

K5960058

• First startup: On-line registration of the display unit is mandatory

• Write down the display PINcode shown on the “Welcome”-screen (current pincode)

• Collect the License PINcode from the envelope. Both PINcodes are necessary to

• Register at https://my.barco.com/productregistration/

• Copy the license file to the root of an USB stick (only license files with the filename

“barcoLicense” will be recognized by the display unit)

• Feed the USB stick into one of the USB ports

• The display unit is registered

• In case of problems: Check the “first operation” section in the user manual for more

information or contact Barco.

• Unpack the display unit and place it up-right on a flat and stable surface.

• Collect the envelope from the box. This envelope contains the license pincode for

the registration of the display unit.

• Set the Picture (!) to the required luminance. The default value is 100 cd/m2.

• Correct the black level by setting the Background ( ) of the display unit.

• Toggle the  button until the required color working space is selected (e.g. SMPTE RP145).

• Set the input signal properties manually in case the display unit cannot identify the type of input signal

• Press  to enter the OSD menu.

• Use the trackball to move to the submenu “Input settings”.

• Select the type of input that is connected to the input board (Single or Dual link).

• When the signal description in this submenu is not correct, override the signal detection and set the input signal

properties manually. E.g. for Dual Link: RGB, 4:4:4, 10 bit and Segmented frame.

a – power button

b – background

c – picture

d – input selection buttons

e – color working space button

f – menu button

Unpack

Barco RHDM-1701B Quick start guide

Brand: Barco

Model: RHDM-1701B

Type: Quick start guide

This manual is also suitable for

RHDM-1701P

Download PDF

report

Barco RHDM-1701B Quick start guide

This manual is also suitable for

Barco RHDM-1701B Quick start guide

Related papers

Other documents