OWNER’S MANUAL
February 1998 OM-187 662-B
Use above FORM number when ordering extra manuals.
Turntable (043 699)
WARNING
ELECTRIC SHOCK can kill.
• Do not touch live electrical parts.
• Turn Off welding power source, and disconnect
input power before inspecting or installing.
FILINGS AND TOOLS HITTING INSIDE
PARTS can damage unit.
• Disconnect input power and remove cover from
welder before drilling any holes.
• Be sure mounting hardware will not touch parts
inside welder.
fwarn 4.1 / swarn 1.1
For S-60 series, install stand-offs (3) in holes labeled A, and secure
feeder base with four 10-24 x 5/8 in screws and washers.
For D-60 series, install stand-offs (3) in holes labeled C, and secure
feeder base with four 10-24 x 5/8 in screws and washers.
For 50 series, install stand-offs (3) in holes labeled A, and secure
feeder base with four 10-24 x 1 in screws and washers.
For 20 series, install stand-offs (3) in holes labeled B, and remove
two rear feet from feeder base before securing base with three
10-24 x 5/8 in screws and washers.
For 10 and 30 series, mark and drill four 7/32 in (6 mm) holes in
feeder base matching the holes labeled A, and install stand-offs (3).
Secure feeder base with 10-24 x 1 in screws and washers.
ST-801 950-B
Part
No.
Item
No.
1 112 180 Screw, 10-24 x 3/4 (8)
2 602 203 Washer, No. 10 lock (8)
3 146 296 Stand-Off, No. 10-24 x 1-9/16 (4)
4 187 658 Tray, turntable (1)
5 152 461 Nut, 1/4-20 (6)
6 187 660 Bracket, holder (1)
7 187 659 Bracket, holder (1)
8 108 941 Screw, 1/4-20 x 1 (6)
9 604 247 Screw, 10-24 x 3/8 (1)
10 175 338 Weatherstripping (1)
11 189 450 Label, Warning (1)
Y Remove cover from welder before drilling
holes.
Be sure to provide Model when ordering replace-
ment parts. Not all hardware may be needed for
each application.
Description (Qty)
5/16 in
Tools Needed:
3
2
1
Top View
A
A
A
A
B
C
C
B
C
B
C
4
5
6
7
8
9
B
Cut and apply supplied weather-
stripping (10) under bracket edges
to protect paint.
11
Figure 1. Installing Turntable
/