SPD-1E/SPD-1K/SPD-1P Owner’s Manual Supplement

Playing User Samples

You can create an audio le (WAV) on your computer, and use the “12” position of the sounds knob to load that audio le into this unit and

play it as a user sample (a sound that you’ve created). Just as with the built-in sounds, you can adjust the user sample’s tuning (pitch) and apply

an eect to it.

Audio les that can be played

back by this unit

WAV format les, 44.1 kHz, 16-bit

* If the user sample is stereo, it is automatically

3. While holding down the [INST VARIATION] button, use a micro-USB cable to connect this unit to your computer.

4. Open the removable disk or “SPD_ONE” that appears on your computer screen.

5. Copy the audio le that you want to import to the unit into the removable disk or “SPD_ONE.”

6. When the copy is completed, disconnect the micro-USB cable.

* Be sure to end the connection with your computer before unplugging the micro-USB cable. Unplugging the cable while your computer is

processing data might cause the data to be damaged.

7. When the TRIG indicator blinks, press the [INST VARIATION] button.

The TRIG indicator blinks rapidly, and the audio le import begins.

* If the TRIG indicator does not blink rapidly, check “Audio Files This Unit Can Play,” and try the procedure again from step 3.