Bogen TBSF is a Tile Bridge Support designed to offer additional mounting support for the Bogen High-Fidelity, Small-Footprint Speaker (Model HFSF1) and Compact Ceiling Speaker (Model SEC4T) when mounted in a suspended ceiling installation.
TBSF is installed by placing it on top of the ceiling tile, aligning the ends of the TBSF rails with the sides of the tile. The ceiling speaker is then mounted in the center of the ceiling tile, ensuring that the TBSF rails are flush with the tile sides. A hole is then cut in the ceiling tile using the ring as a guide, and the tile is sandwiched between the TBSF and the front bezel of the speaker. Finally, the speaker clamps are secured and the speaker installation is completed as directed in the speaker instruction manual.
Bogen TBSF is a Tile Bridge Support designed to offer additional mounting support for the Bogen High-Fidelity, Small-Footprint Speaker (Model HFSF1) and Compact Ceiling Speaker (Model SEC4T) when mounted in a suspended ceiling installation.
TBSF is installed by placing it on top of the ceiling tile, aligning the ends of the TBSF rails with the sides of the tile. The ceiling speaker is then mounted in the center of the ceiling tile, ensuring that the TBSF rails are flush with the tile sides. A hole is then cut in the ceiling tile using the ring as a guide, and the tile is sandwiched between the TBSF and the front bezel of the speaker. Finally, the speaker clamps are secured and the speaker installation is completed as directed in the speaker instruction manual.
Bogen TBSF is a Tile Bridge Support designed to offer additional mounting support for the Bogen High-Fidelity, Small-Footprint Speaker (Model HFSF1) and Compact Ceiling Speaker (Model SEC4T) when mounted in a suspended ceiling installation.
TBSF is installed by placing it on top of the ceiling tile, aligning the ends of the TBSF rails with the sides of the tile. The ceiling speaker is then mounted in the center of the ceiling tile, ensuring that the TBSF rails are flush with the tile sides. A hole is then cut in the ceiling tile using the ring as a guide, and the tile is sandwiched between the TBSF and the front bezel of the speaker. Finally, the speaker clamps are secured and the speaker installation is completed as directed in the speaker instruction manual.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI