1
CHAIN LINK ROLLING GATE KIT
INSTALLATION GUIDE
Item Description
With our Chain Link Rolling Gate Kit, you can add security to any driveway. Our Kit comes with all the
components needed to properly create a Rolling Gate for your Chain Link Fence. Follow these steps and you
can be on your way to properly installing a Rolling Gate.
Features
All parts are Galvanized Pressed Steel
Nuts & Bolts included
On-site assembly
Zero Maintenance
Easily Transported/Compact Box
Please read these instructions carefully before installing your XCEL Fence. If you have any questions or
issues installing the fence, please contact us at 866-392-0808 for assistance.
Tools You Will Need
Socket Set, Pliers, Level
Hammer, All parts from this Kit
ATTENTION:
PLEASE MAKE SURE ALL CONTENTS ARE IN THE FENCE KIT.
DO NOT ATTEMPT TO ASSEMBLE THE FENCE IF PARTS ARE MISSING OR DAMAGED.
Please do not return the product to the store, for assistance or replacement parts call:
866-392-0808
2
Product Overview
Key Notes
Measuring for Gates
o Make sure that you get more than one measurement. Following a level plane, you will want
to measure both at the top and bottom of the gate
o Make sure your measure tape is straight and avoid sloping
o Keep your dimensions accurate to 1/8” buffer
Rolling Gates.
o Measure from inside to inside of gate posts and from inside to inside of adjoining line posts
that will support the gate when in the full open position
o The inside to inside of line post should not exceed 8’
Cantilever Gates
o Measure from inside to inside of the latch posts to the first gate/roller post.
o This would be the gate post closest to the opening.
o Then, measure from outside to outside of the gate/roller gate posts
Installation
1. Make sure that you set your posts that will support your track on 8’ centers and used at least 2-1/2”
posts.
2. A rolling gate uses two wheels installed on the back vertical support of the gate
3. Install your universal track brackets one foot from the bottom of the fence and one foot down from
the top of the fence.
4. Install your rear track wheels on the rear vertical support of the gate. These wheels will be about 1’
from the top and bottom of the gate. Wheels are to be installed on the outside face of the gate.
5. Install the double wheel carrier as far forward as you can on the bottom horizontal member of the
gate.
6. Roll the gate through the opening. Adjust the rear track wheel if necessary. The double wheel
3
assembly has an axle trim bolt that allows you to control the direction of the gate as it rolls through the
opening.
-
1
-
2
-
3
Xcel RRG9001 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
DKS 9024 115V Jan 2016 - July 2018 User manual
-
-
Linear SLC User manual
-
-
-
DKS Enterprises 9100 User manual
-
Chamberlain HS670 User manual
-
-
-
DKS 9245 User manual
