© 2015 Communication Networks. All Rights Reserved. “ComNet,” the “ComNet Logo,” “CopperLine,”
and the “CopperLine Logo” are registered trademarks of Communication Networks.
3 CORPORATE DRIVE
|
DANBURY, CONNECTICUT 06810
|
USA
|
T: 203.796.5300
|
F: 203.796.5303
|
TECH SUPPORT: 1.888.678.9427
|
INFO@COMNET.NET
8 TURNBERRY PARK ROAD
|
GILDERSOME
|
MORLEY
|
LEEDS, UK LS27 7LE
|
T: +44 (0)113 307 6400
|
F: +44 (0)113 253 7462
|
INFO-EUROPE@COMNET.NET
INS_PIM1-REV- 12/23/14 PAGE 1
INSTALLATION AND OPERATION MANUAL
PIM1
PASSIVE POE MIDSPAN INJECTOR FOR 10/100TX
INDICATOR LED
PWR
GREEN Power Applied
OFF No Power Applied
10/100TX
ETHERNET IN
10/100TX ETHERNET +
PoE OUT
Output Voltage will be the
same as Input Voltage
POWER IN
12-48VDC / 24VAC
INSTALLATION CONSIDERATIONS
The PIM1 is supplied as a standalone/surface mount (mini size) module. See
Figure A for dimensions.
Units should be installed in dry locations protected from extremes of temperature
and humidity.
WARNING: Unit is to be used with a Listed Class 2 power supply.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient - Consideration should be given to installing
the equipment in an environment compatible with the maximum ambient
temperature (T
ma
) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment should be such that
the amount of air flow required for safe operation of the equipment is not
compromised.
FIGURE A
Dimensions are for a standard ComNet mini module
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Comnet CLFE4+2SMS Series User manual
-
-
-
-
-
-
Comnet Copper Line CLFE8EOC User manual
-
-
-