Page is loading ...
360.36 mm
13.4 in.
270.50 mm
10.65 in.
CRD9500-F800ER
8-bay Ethernet/Charge Cradle
Installation Guide
72-144328-02 Revision A — February 2015
1. Install four screws into the wall using
the dimensions indicated on the right.
The screw heads should protrude
2.5 mm (3/32”) from the wall.
3. Connect an Ethernet cable to Port 1 on
the top cradle.
4. Align the 8-bay cradle’s four mounting
holes with the four screws on the wall.
5. Place the 8-bay cradle on the screws
and ensure that the cradle is secure.
6. Plug the Power cable into an AC
outline.
CAUTION
Use mounting hardware (screws and/or
anchors) appropriate for the type of wall you
are mounting the bracket onto. The 8-bay
Cradle mounting slots dimensions are 5 mm
(0.2 in.). Fasteners must be able to hold a
minimum of 18.1 Kg (40 lbs.)
For proper installation consult a professional
installer. Failure to install the 8-bay Cradle
properly can possibly result in damage to the
hardware.
Zebra reserves the right to make changes to any product to
improve reliability, function, or design. Zebra does not assume any
product liability arising out of, or in connection with, the application
or use of any product, circuit, or application described herein. No
license is granted, either expressly or by implication, estoppel, or
otherwise under any patent right or patent, covering or relating to
any comb
ination, system, apparatus, machine, material, method,
or process in which Zebra products might be used. An implied
license exists only for equipment, circuits, and subsystems
contained in Zebra products.
Zebra Technologies Corporation
Lincolnshire, IL U.S.A.
http://www.zebra.com
Zebra and the Zebra head graphic are registered trademarks of ZIH
Corp. The Symbol logo is a registered trademark of Symbol
Technologies, Inc., a Zebra Technologies company.
© 2015 Symbol Technologies, Inc.
WALL MOUNTING
Mounting Hole
SHELF MOUNTING
1. Attach the shelf bracket to the bottom
of the 8-bay cradle using four M4x0.7
8 mm screws.
2. Place the 8-bay cradle on the shelf
with end of the shelf bracket hanging
over the shelf lip.
3. Slide the J-bracket onto the shelf lip
and shelf bracket and secure using
two M4x0.7 8 mm screws.
4. Feed the belt through the bracket slot
and the J-bracket slot.
5. Feed the belt through the buckle.
6. Slide the J-backet onto the shelf lip.
7. Tighten the belt.
8. Connect an Ethernet cable to Port 1 on
the top cradle.
9. Plug the Power cable into an AC
outline.
Shelf Bracket
Shelf Bracket
J-bracket
Shelf Bracket
J-Bracket
Strap
Strap Buckle
J-bracket
/