Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall
Determine your desired location for installation and make a mark for the location of the mounting plate and CARD-58 CAP.
Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting
plate over mark made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the
mark. (You may substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place
mounting plate over holes and secure to mounting surface using screws as shown below.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
CV-1TB-16-GAL
MOUNTING PLATE
DRILLED HOLES
PERSPECTIVE
BACKPLATE
SET SCREW
MOUNTING PLATE
SCREW
WALL ANCHOR
DRILLED HOLE
DETAIL A
A
Step1: Attach Bracket to Mounting Plate
Place bracket on mounting plate and secure by tightening set screw as shown below.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
CV-1TB-16-GAL
PERSPECTIVE
DETAIL D
D
BACKPLATE
MOUNTING PLATE
SET SCREW
-
1
-
2
Allied Brass CV-1TB-16-GAL-CA Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI