LAMONA LAM9500 Operating instructions

Brand: LAMONA

Model: LAM9500

Type: Operating instructions

LAM9500 Downdraft hob in 950

deep island

Installation Instructions

Contents

Installation Instructions

1. Remove the rear right foot from the base cabinet.

Rigid

Ducting kit should be placed within the service void.

Flexi

Rigid cut to length

Fan under plinth

Carbon ﬁlter

under plinth

Ducting routing

LAM9500 Page 1

1000 Base unit

1000 Wall unit

290mm575mm

1000 Base unit

1000 Wall unit

A B

C D

NOTE: THIS APPLIANCE IS DESIGNED FOR RECIRCULATION INSTALLATION ONLY

LAM9500

3. The rear and base of the wall cabinet will need to

be cut using the template provided. It has a fold in it

so that you can create the rear and base cut in

one go.

4. Tape the ﬂexi ducting and C together and

feed into the service void. Then join the wall and

base cabinets together using ﬁxing plates or

timber offcuts.

FIT THE FEET TO THE WALL CABINET.

cut the template out and fold along the dotted line

then measure 255mm from the centre of the hob/

cabinet and mark the position.

Place centre line of the template on the cabinet,

make a mark and then fold over the bottome panel

and cut out the base and bottom panel around the

template

2. The back wall of the base cabinet and top rails require cutting prior to joining to the wall cabinet.

Front top rail

515mm

230mm

255mm

110mm

100mm100mm

105mm

15mm

20mm

170mm

Cut out from

template

Fixed area

Cut out in base

Centre line of hob/

cabinet

Page 2

LAM9500

5. Fit the fan motor into the carbon ﬁlter box.

Fit D to the fan motor and position under the wall cabinet. Connect the ﬂexi ducting to D.

6. Cutting the breakfast bar(950mm) for the hob.

Connect B (vertical 900) to C ﬂexi ducting, then cut a rigid rectangular pipe to 150mm long and ﬁt it to B. Then ﬁt A

horizontal to the rigid pipe.

Filter

box

Fan

1000 Base unit

1000 Wall unit

USE THE DUCTING TAPE PROVIDED TO SEAL ALL OF THE JOINTS.

1080mm

750mm

500mm

55mm

Front of worktop

Page 3

This is why the foot

has to be removed

Rigid

B C

LAM9500

7. Position the island into it’s ﬁnal location, route and

ﬁx decor ends to the island unit.

9. Position the hob into the cut out breakfast bar

using the seal provided.

10. Connect the ducting to the hob and ﬁx the hob

into place using the brackets provided.

11. Plug the hob into the fan unit under the cabinet

and connect the electrics.

12. Cut the plinth for a plinth vent on the rear of the

island, NOTE: FOR FILTER CHANGES YOU WILL HAVE TO

REMOVE THE PLINTH.

13. Fit the plinth to the front of the island then ﬁt the

vented plinth to the rear of the island as required.

14. Clean up, then power on and test.

8. Fix the worktop to the island unit.

SLIDE THE HOB SIDEWAYS INTO CUTOUT AND DUCTING AND

GENTLY SLIDE INTO PLACE.

Page 4

LAM9500 Downdraft hob in 950

deep island

Installation Template

Please cut the below template out

LAM9500

FOLD

160mm wide

223mm wide

LAMONA LAM9500 Operating instructions

LAMONA LAM9500 Operating instructions

LAMONA LAM9500 Operating instructions

Related papers

Other documents