morse 311-1-115, 311-1-220-50, 311-1-230, 311-3-230, 311-3-230-50, 311-3-400-50, 311-3-460, 311-3-575 Operators Manual and Parts Diagram

Hello! I've reviewed the user manual for the Morse Automatic Control Package for Tilt-To-Load Drum Tumblers. This document provides instructions on setting rotation time, starting, stopping, and recovering operations of the drum tumbler. I'm ready to assist you with any questions you may have about operating this equipment.
How do I adjust the rotation time?

How do I start the rotation cycle?

How do I stop the rotation?

How to restart after a stop?

How do I reset the rotator to the beginning?

MORSE MFG. CO., INC. • 727 West Manlius Street • P.O. Box 518 • East Syracuse, NY 13057-0518

Phone: 315-437-8475 • Fax: 315-437-1029 • Email: service@MorseDrum.com • Webpage: MorseDrum.com

The Specialist In Drum Handling Equipment

Automatic Control Package

for Tilt-To-Load Drum Tumblers

Operating Instructions for Morse Automatic Control Package for Tilt-To-Load Drum Tumblers

with Serial Number 245345

Operating Instructions

Adjust the timer: using the small buttons on the timer, set the desired time of rotation to the nearest tenth of 1.

a minute.

Press the green “START” button to begin the cycle: 2.

a. The drum holder will rise to the top position

b. Start the slow speed rotation for about 5 seconds

c. Rotate at the high speed setting (The high speed setting is adjusted using the black knob on the top of the

hydraulic manifold – see image above. If the black knob is turned fully clockwise, the drum will rotate at full

speed. As the black knob is turned counterclockwise, the high speed setting is lowered.)

d. Stop rotating after the preset time has been reached

e.Lowersbacktotheoorintheuprightposition.

If at any time the operator needs to stop the rotator, the red emergency stop or the red “STOP” button can

be pressed and the rotation will stop. One of two actions can then be performed:

a. To restart rotation from that point, press and release the black “RECOVERY” button, then press the green

“START” button to restart the rotation from the point it was stopped and rotate until the end of the timer

cycle.

b. To reset the rotator to the beginning of the cycle, without waiting through the timer cycle, press and hold

theblack“RECOVERY”buttonuntilthedrumholdercomestorestontheoor. 

If the safety switch interrupts the process by opening the gate on a safety enclosure, for example, follow step

3 to recover after closing the gate.

Control Panel Hydraulic Manifold