Harman Log Kit Installation guide

Hello! I've reviewed the P-Series Log Kit Instructions, which details installing the log set for P43, P61A, and P68 models. The instructions highlight the placement of the three different sized logs. I'm ready to answer any questions you have about this document and the installation process.
How many different sized logs are there?

What tool is needed to install the log kit?

Where will the largest log be placed?

Tools Required: None

Log bracket not needed

Step 1: After Unwrapping the log set,

you’ll notice there are three different

sized logs.

Step 2: Remove the firebricks from

behind the brick retainer. If the bricks

have yet to be installed, do not install

them.

Step 3: Place the largest of the three

logs into the Brick Retainer. The Brick

Retainer will fit in the slot on the

bottom of the log, and the two

“stubs” will rest on the flame guide.

Step 4: Next, the middle sized log will

lay on top of the large log

Step 5: The smallest log will lay on top

of the middle creating a stack of logs

behind the fire.

P-Series Log Kit Instructions

Part # 3-40-5647 (Fits P43, P61A & P68)

/

Other documents