Scanomat TopBrewer Care And Troubleshooting Manual

Brand: Scanomat

Model: TopBrewer

Category: Coffee makers

Type: Care And Troubleshooting Manual

CARE AND

TROUBLESHOOTING GUIDE

TopBrewer

Cleaning Your Machine

Open the stainless door, and wait

until the piston has risen. Turn o

the TopBrewer using the on/o

button on the front panel of

the machine.

Open fridge & remove milk

bottles. Place milk spear

into an empty glass. Turn

on the TopBrewer.

Remove the stainless steel

casing by turning clockwise and

unhooking from the swan neck

(1). Gently but ﬁrmly pull down

on the black casing (2). Twist the

black frothing head clockwise

to remove(3). Clean all three

pieces in warm water to ensure

all milk deposits are removed.

Dry & reattach.

Thoroughly wipe underneath the

piston to clean the metal ﬁlter

and wipe all around the O-ring to

remove deposits of coee. Finish

with cleaning the metal ﬁlter on

the bottom piston.

Open fridge and remove the glass

which will have some cleaning

water in it. Wipe the inside of the

fridge with a damp cloth and

replace with fresh milk.

Brush around the top of the brew

unit, using the long handled brush

in order to remove any ground

coee deposits.

Prior to use, prime the TopBrewer

by dispensing one warm milk or a

milk based drink.

The stainless steel cylinder top

must be completely clean with no

coee remains. Push the scraper

arm back in place.

Remove lid from bean hopper

and wipe with a damp cloth prior

to ﬁlling with beans. Note: Fresh

TopBrewer beans have great

ﬂavor. To ensure its quality, do

not overﬁll the hopper. Store

unused beans in a sealed bag

somewhere cool.

Place a TopBrewer cleaning tablet

into the center of the scraper.

Close the stainless door.

The machine will notify you in

the status bar of the app when

the dregbin containing the coee

remains is full. When removing

the dregbin, the unit will reset its

counting system and will assume

that you have emptied it. There,

empty the dregbin once removed

from the unit.

The machine is designed for coee beans only. Please read the instructions carefully before attempting to clean the machine. We recommend cleaning your TopBrewer daily by following the steps 6 through 9 if it is

used in high volume settings, but in some cases, the cleaning frequency can be less depending on the milk type, fat content, humidity and temperature. It is recommended to follow the complete cleaning instructions

once a week. A clean machine makes better coee. We only recommend using TopBrewer labeled cleaning solutions that have been proven to properly clean the machine. For further information, please refer to the

user manual. Additional cleaning tablets available: CLNTAB $45 for QTY 25.

If the drain of your Top Brewer

is plumbed: lower the swan neck

to its lowest position, and select

the “CLEAN” button from the

front panel menu. The process

will take approximately 1 minute

and “Machine is ready” will appear

in the status bar in the app once

completed. If your drain is not

plumbed: be sure to place a

container under the swan neck

BEFORE selecting the “CLEAN”

button from the front panel menu.

TopBrewer

Cleaning the Ice Bank/Milk Fridge

If system is plumbed, lower the TopBrewer

swan neck to its lowest position.

If system is not plumbed, place a cup under

faucet tip.

Remove milk carton and replace with a

container ﬁlled with 300 ml of hot water.

Place milk line inside container.

Hit “Warm milk” on iPad or other device.

Repeat 2-3 times to ensure milk lines have

been rinsed. Wipe fridge interior using clean

rag.

TopBrewer

Troubleshooting

PISTON ERROR This means the met-

al screen (picture 1) is being opened

numerous times in a short period

of time. Make sure the metal screen

is in the closed position. The error

message on your iPad or iPhone will

give you the option to reset; Please

choose reset. The piston should then

move to its designated position.

DREGBIN FULL To empty the dreg-

bin, simply follow the directions in

the diagrams below. Important: Every

time you open the metal screen

(picture 1), the system automatically

resets the counter for dregs (coffee

pucks). It is very important that you

monitor if you continue to open

the metal screen as the system will

continue to reset the count. Standard

count is 50 coee pucks. Note: If the

metal screen is not closed entirely,

you will have an error message of

“Door open”. Make sure the metal bin

(picture 2) is situated properly.

WASTE BIN FULL / MISSING Also

known as “overﬂow dregbin” (picture

3). This bin is located at the bottom

of the machine. You will need to

empty this frequently. There is a sen-

sor, so the system will prompt you to

empty. Note: If you do not return the

bin, the machine will show an error

message of “Waste bin missing”.

BEAN HOPPER EMPTY This simply

means the unit needs to be replen-

ished with coee beans. Picture 4

shows where the bean reservoir is

located. The machine can be pulled

forward for easy access to load the

beans. There is a locking arm on the

right side of the machine that will

need to be pulled up in order to pull

the machine forward. The machine

is on a track system. The hopper can

accommodate one bag of TopBrewer

Coee Beans.

To access the brewing chamber, simply lift

the perforated metal screen and slide it

backwards.

To empty the coee dregbin, pull out gently;

empty contents and return bin to home. The

display indicated when full.

To empty overﬂow dregbin, slowly slide out

the metal drawer at the bottom of the unit

out; empty and replace. The Display will

indicate when full.

Above the keyboard at the top of the unit,

you can lift the metal lid for access to the

bean reservoir.

1 2 3 4

TopBrewer

System Map

Scanomat TopBrewer Care And Troubleshooting Manual

Brand: Scanomat

Model: TopBrewer

Category: Coffee makers

Type: Care And Troubleshooting Manual

Download PDF

report

Scanomat TopBrewer Care And Troubleshooting Manual

Scanomat TopBrewer Care And Troubleshooting Manual

Other documents