Figure 7c
1.
Figure 7a
Figure 7b
Slip the mounting plate into the slots in the upper plate.
(See Figure 7a)
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
Assemble the handle by inserting the M6x20 screws, at
washers, and nuts thru the middle holes in the upper plate.
(See Figure 7b)
Attach the upper plate and mounting plate using the
M8x20 bolts and nuts. ( See Figure 7b)
Attach the support wheels to the lower plate by M4x10
screws, at washers, spring washers, and nuts. (See Figure
7c)
2.
4.
3.
M6x20 (x2)
M8x20 (x2)
Mounting Plate
Upper Plate
M4x10 (x4)
Lower Plate
M6 X 20 X 2 4
M8 X 20 X 2
M4 X 10 X 4 5
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
X 2
Tongue
Mounting Plate
Upper Plate
Align the holes in lower plate with the holes in upper plate.
Tighten both plates together by inserting the two M5x12
bolts and nuts through hole 1 and hole 4.
Attach the handle through hole 2 and hole 3 using the two
M6x20 screws, at washers and nuts. (See Figure 7d)
5.
6.
ASSEMBLY
2
|
Assembly
Figure 7d
M5 X 12 X 2 6
M6 X 20 X 2
M5x12 (x2)
2
134
2
134
M6x20 (x2)
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
X 2
3
28” Dust Collection Bucket
»
Operator’s Manual
Assembly
|
Figure 7g
Figure 7f
Figure 7e
M8x45 (x2)
Pin
M5 X 12 X 36 7
M5 X 12 X 4 8
M8 X 45 X 2 9
Align the two side-plates with main body, assemble
them together using the 36 M5x12 bolts and nuts. (See
Figure 7e)
Put the rubber sheet under back plate. Assemble back
plate and rubber sheet with the unit. The rubber sheet is
designed to hang below the back plate of the bucket to
aid with collection (See Figure 7f)
Attach the two pins into the guard plate using M8x45 bolts
and nuts. (See Figure 7g)
7.
8.
9.
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
X 2
M5x12 (x38)
Side-Plate
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
X 2
Figure 7h
Hang the tongues through the pins, and secure to desired
height using the bridge pins. (See Figure 7h)
10.
Bridge Pin
Pin
M5x12 (x4)
Rubber Sheet
Back Plate
10
mm
13
mm
18
mm
16
mm
7
mm
8
mm
X 2
/
