Minka Group 73191-715 User manual

Minka Group
Brand
Minka Group
Model
73191-715
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
For Model 73191-66/73191-715
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig. 2
Fig. 3
HANGING THE FIXTURE (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box
and remove the old fixture including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Attach the mounting plate (D) to the outlet box (A) (not
supplied) with mounting screws (C). (Size: #8-
32*0.78"L). The side of mounting plate marked “GND”
must face out.
CONNECTING THE WIRES (Fig. 2).
4. Connect the electrical wires as shown in Fig.2. Making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate (D)
using the green screw provided.
COMPLETING THE INSTALLATION (Fig.1)
5. Align the fixture back plate to mounting plate (D) and
secure with decorative nuts (E).
6. Install (1) one medium base bulb up to 100 watts or
CFL or LED equivalent (not included) in accordance
with the fixture specification.- DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
7. Insert the glass shade (L) into the cage (M), secure the
glass ring (K) with flat heads screws (J).
8. Install the middle ring (I) to the cage (M) with screws
(H). Install the complete cage to the fixture roof (F) with
washers (N) and screws (G).
9. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. Indoor/Outdoor
Silicone Sealant) to outline the outside of fixture back
plate where it meets the wall leaving a space at bottom
to allow moisture a means to escape (Fig. 3).
Your installation is now complete. Return power to
the
junction box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)
Caulking
Backplate
  • Page 1 1

Minka Group 73191-715 User manual

Minka Group
Brand
Minka Group
Model
73191-715
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents