13
Maintaining and cleaning
4 Maintaining and cleaning
Cleaning or replacing the filter
– Before changing or cleaning the filter, switch the appliance off and disconnect the plug from the
outlet.
– The dual motor filter's foam plastic insert can be washed, it can not however be washed in the
dishwasher or washing machine. Rinse the dual motor filter's foam plastic insert out thoroughly
under running water (illustrated Quick Start Guide, page 3). Allow the dual motor filter's foam
plastic insert to dry for approx. 24 hours at room temperature after cleaning. Only replace the
dual motor filter's foam plastic insert when it is completely dry.
– To clean the dual motor filter's laminated filter, first knock the dust out of it then brush with a soft
brush (illustrated Quick Start Guide, page 3).
– To clean the exhaust filter, first knock the dust out of it then brush with a soft brush.
(illustrated Quick Start Guide, page 4).
For the filter cleaning, see also illustrated Quick Start Guide.
Cleaning
– Before cleaning, switch off the appliance and disconnect the plug from the outlet.
– The housing and power cable may not be handled with liquids or immersed in liquids for reasons
of electrical safety. Rub housing with a slightly damp cloth and then dry.
– For cleaning, do not use any sharp or scouring cleansers or hard brushes.
Troubleshooting by yourself
So that as few problems as possible arise, it is important to empty the dust container regularly and
take this opportunity to check the filters and clean them if they are dirty.
If you still have problems with the appliance, first visit us on the Internet at
www.severin.com/go/to/8360 under "FAQs" and try to fix the problem by
yourself.
Use this QR code to reach our home page directly.
If this does not help, contact our customer service.
The contact data is in the appendix to this instruction manual or on our home page.
CY7085.book Seite 13 Freitag, 1. August 2014 4:41 16