Samsung vcc 8480 h3r User manual

Page is loading ...

VACUUM CLEANER

❈

Before operating this unit, please read the instructions carefully.

❈ Indoor use only.

Register your product at www.samsung.com/register

Operating Instructions

EN

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 13

IMPORTANT SAFEGUARDS

1. Read all instructions carefully. Before switching on, make sure that the voltage of your

electricity supply is the same as that indicated on the rating plate on the bottom of the

cleaner.

2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.

Do not use to suck up water.

3. Close supervision is necessary when any appliance is used by or near children. Do not

allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run

unattended at any time. Use the vacuum cleaner only for its intended use as described in

these instructions.

4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in

order to maintain the best efficiency.

5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the

vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour

the plastic parts of the unit.

6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the

cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not

block the suction or the exhaust port.

7. Switch the vacuum cleaner off on the body of the machine before unplugging from the

electrical outlet. Disconnect the plug from the electrical outlet before changing the dust

bag or dust container. To avoid damage, please remove the plug by grasping the plug

itself, not by pulling on the cord.

8. This appliance is not intended for use by persons (including children) with reduced physi-

cal, sensory or mental capabilities, or lack of experience and knowledge, unless they have

been given supervision or instruction concerning use of the appliance by a person respon-

sible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

9. The plug must be removed from the socket outlet before cleaning or maintaining the appli-

ance.

10. The use of an extension cord is not recommended.

11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult

an authorized service agent.

12. If the supply cord is damaged, it must be replaced by the manufacturer or its service

agent or a similarly qualified person in order to avoid a hazard.

13. Don’t carry the vacuum cleaner by holding the hose.

Use the handle on the vacuum cleaner set.

EN-1

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 14

1

ASSEMBLING THE CLEANER

Features may vary according to model.

OPTION

▼

For storage, park the floor nozzle.

OPTION

CAUTION :

Please do not use dust bin handle

when carrying machine.

EN-2

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 15

2

OPERATING THE CLEANER

2-1 ON/OFF SWITCH 2-2 POWER CORD

2-3 POWER CONTROL (INFRARED CONTROL)

HANDLE CONTROL

NOTE : If the remote handle control is not

working, the cleaner can be operated

using the control button on the body

of the machine.

1. Vacuum cleaner ON/OFF

Press the ON/OFF button to operate the vacuum

cleaner.

Press again to stop the vacuum cleaner.

2. Vacuum cleaner MIN/MID

Press the MIN/MID button to operate the vacuum at a

low level (for curtain cleaning, etc.).

Press again to operate the vacuum in a MID mode.

3. Using at MAX

Press the MAX button to operate the vacuum at maxi-

mum intake.

Press the power control button repeatedly to select

the correct mode.

(ON(MIN) → MID → MAX → OFF)

SENDER

1) REMOTE CONTROL TYPE

- HOSE

- BODY

NOTE

When removing the

plug from the

electrical outlet, grasp the

plug, not the cord.

POWER CONTROL

RECEIVER

OPTIONAL - DIGITAL SIGNAL

EN-3

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 16

2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES

To reduce suction for cleaning draperies,

small rugs, and other light fabrics, pull the

tap air until the hole is open.

MIN = For delicate surface e.g. net curtains.

MAX = For hard floors and heavily soiled carpets.

2) BODY-CONTROL TYPE

- HOSE

- BODY

Adjust the length of the telescopic pipe

by sliding the length control button locat-

ed in the center of the telescopic pipe

back and forth.

To check for blockages, separate the tele-

scopic pipe and adjust to shorten. This allows

for easier removal of waste clogging the tube.

PIPE

ACCESSORY

Push the accessory on to

the end of the hose han-

dle.

Pull out and turn the dust-

ing brush for cleaning deli-

cate areas.

To use the upholstery tool,

push the accessory on to

the end of the hose handle

in the opposite direction.

ELBOW EXTENDING TUBE

(OPTION)

1. Connect the elbow extending tube to connecting part for hose knob and

telescopic pipe.

2. Fit the telescopic pipe to the lower part of the elbow extending tube.

3. Press the PUSH button.

4. With the PUSH button pressed, the elbow extending tube is folded.

5. Using the elbow extending tube allows hard to reach areas (e.g. under

furniture)to be cleaned without having to kneel down.

1234 5

Features may vary according to model.

▼

EN-4

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 17

For improved pick-

up of pet hair and

fibre on carpets

OPTION

1 2 3

4

Remove dust inside the

brush housing using a

dry duster or crevice tool.

5

Insert brushbar into

rotating belt and

assemble.

6

Click the transparent

screen cover back into

place to reassemble.

Push the Open button of

the transparent screen

cover to separate the cover.

Remove the brushbar

from the transparent

screen.

Remove waste matter

such as dust and hair

tangled around the

brushbar using scissors.

Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to

matters tangled around the drum. In this case, clean the drum with care.

Remove waste matter completely if the

inlet is blocked.

Adjust the inlet lever according to the

floor surface.

OPTION

Carpet

Cleaning

Floor

Cleaning

Vacuum dust in wide area at once

OPTION

Remove waste matter completely

if the inlet is blocked.

For picking up pet hair

and fibre on upholstery

and bed linen.

Remove waste

matter com-

pletely when

inlet is blocked.

Turn the lock button to

‘UNLOCK’, and remove

waste matter.

Turbine

Brush

To reassemble, align the cover to the

front of the main body and close. After

closing the cover, ensure that the lock

button is turned to the ‘LOCK’ position.

Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.

Clogs on turbine keeps brush from turning, and in this case, take care of it.

OPTION

Brush for blanket

EN-5

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 18

Once dust reaches the dust full

mark, or once the dust

full light is on, empty the dust bin.

Take the dust bin out by

pressing the button.

Separate the dust

bin cover.

Throw away dust in

the bin.

Close the dust bin cover.

Before use, push the dust bin

into the main body of the vac-

uum cleaner until you hear

the "click" sound.

1 2 3

4 5

CLICK

6

3

EMPTYING THE DUST BIN

NOTE

You may rinse the dust bin with cold water

- Empty into a plastic bag

(recommended for asthma/allergy sufferers)

EN-6

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 19

4

CLEANING THE DUST PACK

4-1. WHEN TO CLEAN THE DUST PACK

Suction is significantly weakened during cleaning.

Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard.

Turn the vacuum power to 'MAX'

If the filter check indicator turns red

with the inlet floating 10 cm above

flat floor, clean it.

When the indicator light comes

on, please empty the Dust

Pack(4-2) as shown in the fol-

lowing illustrations.

- If suction is noticeably reduced during cleaning, please check the dust pack as indicated

below.

HANDLE CONTROL

SENDER

EN-7

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 20

4-2 CLEANING THE DUST PACK

12

4

7 8

NOTE :

Make sure the filter is completely dry before putting it back into the vacuum

cleaner. Allow 12 hours for it to dry.

Remove the dust bin and dust

pack as shown.

Remove the fixed frame

of the dust pack cover.

Remove the sponge and filter

from the dust pack.

Wash the sponge and the filter

of the dust pack with water.

Let the sponge and filter dry in

the shade for more than

12 hours.

Before reassembly,

align the dust pack cover

and dust pack correctly.

Put the assembled dust pack

into the main body.

Put the sponge and filter

into the dust pack.

3

56

EN-8

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 21

6

CLEANING THE OUTLET FILTER

NOTE :

Replacement filters

are available at your

local Samsung dis-

tributor.

Remove and replace the blocked outlet filter.

OPTION - MICRO CARBON FILTER

Take out both the dust bin and the

dust pack.

Press the fixed frame

part at the back of the

main body to remove.

Pull out the HEPA Filter

using the tab.

Dust the HEPA filter. Put the HEPA filter into

the main body until you

hear a ‘click’ sound.

Remove the motor protection filter from

the vacuum cleaner.

Shake and tap the dust from it and put

back in machine.

5

CLEANING THE MOTOR PROTECTION FILTER

EN-9

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 22

PROBLEM CAUSE REMEDY 0

- IF YOU HAVE A PROBLEM

Motor does not start.

No power supply.

Thermal cut-out.

Check cable, plug and socket.

Leave to cool.

Suction force is gradually

decreasing.

Nozzle, suction hose or tube

is blocked.

Check for blockage and

remove it.

Cord does not rewind fully. Check that the cord is not

twisted or wound unevenly.

Pull the cord out 2-3m and

push the cord rewind button.

Vacuum cleaner does not

pick up dirt.

Crack or hole in hose.

Check hose and replace if

required.

Low or decreasing suction

Filter is full of dust.

Please check filter and, if

necessary, clean as illustrat-

ed in the instructions.

7

CHANGE THE BATTERY(OPTIONAL)

WARNING

1. Never disassemble or recharge the batteries.

2. Never heat up the batteries or throw them into fire.

3. Do not reverse (+),(-) poles.

4. Dispose of the batteries properly.

NOTE

1. When the vacuum cleaner does not work, replace the batteries.

If the problem persists, please contact our authorized dealer.

2. Use 2 batteries of size AA.

BATTERY TYPE : AA Size

EN-10

This Vacuum cleaner is approved the following.

EMC Directive : 2004/108/EEC

Low Voltage Safety Directive : 2006/95/EC

DJ68-00321K (NL+EN+FR) (0.4) 3/17/09 8:22 PM Page 23

Page is loading ...

Samsung vcc 8480 h3r User manual

Samsung vcc 8480 h3r User manual

in other languages

Related papers

Other documents