Kathrein WFS 28 Specification

Category
Cable interface/gender adapters
Type
Specification
1 / 2
Remote feeding diplexer with adjustable output voltages:
5/12/14/18 Volt
For remote feeding of BZD 30/BZD 40 DVB-T antennas,
VCA/VCB 20/28 compact ampli ers, VCP 27/35/45/55/66 low
noise preampli ers, UAS 584 feed systems - in conjunction
with the NCF 18 switched-mode power supply unit (not
included with this product)
Proof against overloads and short circuits
Transmission range up to 2.150 MHz
Output with capacitive isolation
For indoor installation
WFS 28 21210025
Remote feeding diplexer
Features
The equipment described is designed solely for the installation of satellite and terrestrial receiver systems.
Any other use, or failure to comply with these instructions, will result in voiding of warranty cover.
The equipment may only be installed in dry indoor areas. Do not install on or against highly combustible materials.
The equipment must be provided with an equipotential bonding wire (Cu, at least 4 mm2).
The safety regulations set out in the
current EN 60728-11 and EN 60065 standards must be complied with.
Fixings: screws, max Ø: 4 mm
Connectors: RF plug 75 (series F) to EN 61169-24.
Incorrect voltage settings can damage the remotely fed equipment!
The voltage selection switch must be set to the correct voltage before the equipment is connected, and must not
subsequently be changed (see system example page 2).
Only the NCF 18 plug-in power supply unit (not included with this product) may be used to supply power.
Installation and safety instructions
A cable inner conductor diame-
ter greater than 1.2 mm or the
presence of burrs can damage
the product‘s sockets.
Max. 2 mm protrusion
Tightening torque max. 3
Nm (risk of overtightening)
Diameter
0.6-1.2 mm burr
free
System examples (symbolic representation)
Technical Speci cations
Electronic equipment is not domestic waste - it must be disposed of properly in accordance with directive
2002/96/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL dated 27th January 2003 concerning
used electrical and electronic appliances. At the end of its service life, take this device for disposal at a
designated public collection point.
936.4180/-/ZWT/0211/e - Subject to technical changes!
Internet: www.kathrein.de
KATHREIN-Werke KG • Anton-Kathrein-Strasse 1 - 3 • Postfach 10 04 44 • 83004 Rosenheim • Germany • Telephone +49 8031 184-0 • Fax +49 8031 184-306
Type WFS 28
Part no. 21210025
Frequency range
MHz 5-2.150
Adjustable remote supply voltage DC V 5/12/14/18 *
)
Remote supply current DC mA Max. 400
Nominal impedance 75
Through loss VHF/UHF/Sat-IF dB 0.4/0.4/1.0
Connections F-type connectors
Permissible ambient temperature S -20 to 55
Dimensions mm 35 x 74 x 21
Packing unit/weight Units/kg 1 (10)/0.09
BZD 30
To the subscribers
To the DVB-T tuner
NCF 18
NCF 18
e.g. low noise ampli er
(VCP .. , 12 V/90 mA)
DVB-T antenna
(e.g. BZD 30, 5 V/35 mA)
*) The 18 V voltage is not controlled, it is simply fed through the NCF 18 power supply unit.
12 V setting
5 V setting
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Kathrein WFS 28 Specification

Category
Cable interface/gender adapters
Type
Specification

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI