Kickback Safety Features
WARNING:
Reduced-Kickback Guide Bar,
Low-Kickback Chain
Do not operate chain saw while in a tree, on a ladder, on a
scaffold, or from any unstable surface.
Hold tool by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring.
Do not attempt operations beyond your capacity or
Before you start chain saw,
Do not operate a chain saw with one hand! Serious injury
to the operator, helpers, or bystanders may result from one
handed operation.
Keep the handles dry, clean, and free of oil or grease.
Do not allow dirt, debris, or sawdust to build up on the motor
Stop the chain saw before setting it down.
saplings
WARNING:
5
and water.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
SAVE THESE INSTRUCTIONS
Symbols
V ................................. volts A..............amperes
Hz ..............................hertz W.............watts
min .............................minutes ..........alternating current
.........................direct current
n
o............no load speed
..............................Class I Construction ............earthing terminal
(grounded)
..........safety alert symbol
..............................Class II Construction .../min or rpm...revolutions or
(double insulated) reciprocation per minute
........................Read instruction ............Use proper
manual before use respiratory protection
..............................Use proper eye protection ...........Use proper
hearing protection