Bunn-O-Matic IMIX-3 Datasheet

Type
Datasheet

This manual is also suitable for

Features
Related Products
ITEM#
PROJECT
DATE
For current specification sheets and other information, go to www.bunn.com.
7/10
D5
iMIX Hot Beverage System with 3 Hoppers
Capacity: three, 8-pound (3.6 kg) hoppers
Large, lighted front graphics for merchandising.
4.4-gallon hot water tank to meet peak serving times.
Cup clearance at 7.25” (18.4 cm) to accommodate popular cup sizes
(adjustable to 8.12” (20.6 cm)).
Key service components easily accessible through front and top.
High speed, heavy-duty whipper for complete product mixing.
Front of machine access to tank drain, dump valves, auger and whipper
motors and control board for easy service.
Key lock on the door prevents tampering.
Contemporary styling for striking visual statement.
Low product detection system alerts audibly and with message on display
when hoppers are low.
New digital technology adds night mode to prevent pilferage.
Alphanumeric display communicates advertising messages, machine status
and technical support contact information.
Spring-loaded, all metal auger drive system for easy hopper installation.
Machine can be ordered with left or right-hinged doors to support side by
side placement.
Front of machine set up and calibration.
Auger motors with RPM feedback monitoring assure consistent flavors and
profits by controlling powder dosing.
Iced Coffee and other displays available.
Top hinged, lift door model available.
Preventive maintenance kit: 32906.0001.
iMIX
®
Hot Beverage System
with 3 Hoppers
iMIX-3
Dimensions: 32.8”H x 12.6” W x 24.1” D
(87.3cm H x 32cm W x 61.2cm D)
Easy Clear
®
EQHP-10
Product No. : 39000.0004
Easy Clear
®
EQHP-10L
Product No. : 39000.0001
Model Agency Listing
iMIX-3
Top hinged, lift door
model available.
Features deluxe whipper chambers:
1. Robust whipper to ensure full flavor
yield.
2. Specially designed self cleaning
mixing chamber.
3. Exhaust fan to siphon off moisture
that can cause powder buildup.
4. Hot water dispense for easy
clean-out.
5. Quick disconnecting parts for
thorough sanitizing.
Replacement Displays
Standard Cappuccino (shown above)
Product No. : 37457.0000
Chai Tea
Product No. : 37457.0001
Hot Chocolate
Product No. : 37457.0002
Steamers
Product No. : 37457.0003
Iced Cappuccino
Product No. : 37457.0006
BUNN
®
practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
Dimensions & Specifications
Bunn-O-Matic
®
Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
4.00
43.06
39.81
4.00
5.75
35.14
32.8
18.49
23.32
23.32
33.4
12.46
32.8
30.19
Model Product # Volts Amps Watts Capacity Cubic Shipping Cord
Measure Weight Attached
iMIX-3 BLK 36900.0000 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs. Yes*
(Cappuccino display)
iMIX-3 SST 36900.0001 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs Yes*
(Cappuccino display)
iMIX-3 PC BLK 36900.0002 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs. Yes*
(Portion control, Cappuccino display)
iMIX-3 BLK 36900.0003 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs Yes*
(Steamer display)
iMIX-3 BLK 36900.0004 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs. Yes*
(Hot Chocolate display)
iMIX-3 BLK 36900.0005 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs Yes*
(Specialty Tea display)
iMIX-3 BLK 36900.0026 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs. Yes*
(Iced Coffee display)
iMIX-3 BLK 36900.0050 120 15 1800 4.5 gal/hr 8.3 ft
3
90 lbs. Yes*
(Top hinged, lift door, Cappuccino display)
*Power cord (NEMA 5-15P) 15 Amp-120V machine only.
Models with door hinges on right side are available by special order.
Burst Capacity: 36-12 oz. servings in 14 minutes. (to -10˚F (-23.3˚C) peak serving temperature)
Electrical: 120V model requires 2-wires plus ground service rated 120V, single phase, 60 Hz.
Plumbing: 20-100 psi (138-690 kPa) from a
1
/
4
or larger supply line. A shut-off valve should be installed in the line before
the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied with
1
/
4
male flare fitting.
7/10 © Bunn-O-Matic Corporation
top hinged model
side view
side hinged model
side views
  • Page 1 1
  • Page 2 2

Bunn-O-Matic IMIX-3 Datasheet

Type
Datasheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI