5.
2.
6.
1.
S TAC K ING K IT INS TAL L A T ION
1)P osition the unit on a level surface,
capable of s upporting the entire
weight of the dryer.
R emember that the unit will be
heavier when it is fully loaded.
C lean the surface where the stacking
kit is going to be installed.
P lace the mounting bracket on the
W as her as indicated.
2) R emove the 2 plastic covers (shown in figure 6) attached
to the middle of the stacking kit, and s ave these for
later use. R emove the double back tape and firmly attach
the s tacking kit the top of the was her to ass ure the
proper s ea l.
Make sure the word F R ONT printed on the stacking kit
is facing forward as shown above.
3) P ut back edge of stacking kit to back mold line of was her
5) Your Dryer is equipped with 4 leveling legs .
Make sure they are lowered 10 mm, s o there is a
gap between the legs and the dryer bas e.
6) G ently pus h the dryer into pos ition as
indicated in figure 5 & 6, s liding the unit into
the slots provided.
It is important that the dryer is level.
Make sure all four leveling legs are pus hed
all the way back into the slots to ensure
proper mounting.
3.
6.
4) Ins tall all 7 screws provided with a power drill
and tighten the stacking kit to the unit bas e s ecurely.
4.
8.
DC 68-01052A
7) Ins ert the plastic covers
(removed in section 2)
covering the two front
slots of the leveling legs .
Depending upon the
location of the unit, it may
be neces s ary to change
the s ide on which the dryer
door opens.
7.
( back )
/
