Eden ENCOD-USB Technical Manual

Access control

ENCOD-USB

Technical Manual

Technical manual ENCOD-USB – V1.2 p.2/8

Contents

Contents ........................................................................................... 2

Acknowledgement ........................................................................... 3

Information and recommendations ................................................ 3

Technical Characteristics ................................................................ 4

ENCOD-USB Set up ......................................................................... 5

1. PC connection...................................................................... 5

2. Configuring the ENCOD-USB in SENATORFX.NET ........... 6

Notes ................................................................................................. 7

Technical manual ENCOD-USB – V1.2 p.3/8

Acknowledgement

Dear client,

You have just purchased an ENCOD-USB, a USB MIFARE encoder built by the French

company EDEN INNOVATIONS.

The entire EDEN INNOVATIONS team would like to thank you for your interest as well as

your confidence in our security solution.

We hope that you will be completely satisfied with the level of security it provides for your

company’s premises.

Should you have any comments, please contact us via our web site at

www.eden-innovations.com

The EDEN INNOVATIONS team.

Information and recommendations

o Pursuant to European directive UTE C00-200, incorporating directives 89/336 EEC and

92/31 EEC, ENCOD-USB complies with the following standards:

 NF EN 50081-1 governing electromagnetic radiation, and

 NF EN 50082-1 governing electromagnetic susceptibility.

o Cabling recommendations: the cables used to connect readers, the network and other

peripherals must be installed in accordance with the instructions for Level 2 (protected

environment) of standard NF EN 61000-4-4.

o This product must be installed by an approved company. Incorrect installation and use

may result in electric shock or fire. Before installation, read the technical information and

comply with the recommendations for installing the product.

o Once the power is turned off, all the internal capacitors will discharge themselves to a

safe level after 60 seconds under normal conditions. However, in the event of a power

failure, the charge may be maintained for much longer and suitable precautions

should be taken before handling the product.

Technical manual ENCOD-USB – V1.2 p.4/8

Technical Characteristics

Weight ............................................. 77 g

Housing dimensions ........................ 104 x 64 x 20 mm

Operating temperature .................... +10°C to +50°C

........................................................ +50°F to +122°F

Compatible USB types......................USB 1.1 / USB 2.0

Compatible with Windows®..............2000, XP, VISTA, 7

Software

SenatorFX ....................................... V4.0.0 ou supérieure

SenatorFX.NET ............................... V1.1.5.0 ou supérieure

Technical manual ENCOD-USB – V1.2 p.5/8

ENCOD-USB Set up

1. PC connection

Connect the ENCOD-USB to an available USB port on your computer using the cable provided.

No additional drivers are required for installation.

USB Port 1.1 / 2.0

Workstation

Technical manual ENCOD-USB – V1.2 p.6/8

2. Configuring the ENCOD-USB in SENATORFX.NET

To activate the ENCOD-USB interface in SENATORFX.NET, click on the "Technique" tab, then

select the "Site configuration" option, and proceed as follows:

Click on "Site configuration"

then on "Add an encoder"

Once the EncodUSB is created

it will appear in the list

Technical manual ENCOD-USB – V1.2 p.7/8

Support Technique :

[email protected]

Notes

-------------------------------------------------------------------------------------------------------------------------------

Zone Commerciale et Artisanale

670, route de Berre

13510 EGUILLES

France

www.eden-innovations.com

Eden ENCOD-USB Technical Manual

Eden ENCOD-USB Technical Manual

Related papers

Other documents