BMW 51 47 0 027 792 Installation Instructions Manual

Brand: BMW

Model: 51 47 0 027 792

Type: Installation Instructions Manual

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

F 46 0753 EVA

BMW aluminium footrest

BMW 3 Series (E

46)

Specialist knowledge required.

The installation time is approx. 0.5 hours, but this may vary depending on the condition of the

car and the equipment in it.

Retrofit / Installation kit No. 51 47 0 027 792

BMW Parts and Accessories

Installation Instructions

EN/2

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

Contents

Section Page

1. Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

2. Preparations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

3. Parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

4. To install the BMW aluminium footrest. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

5. To assemble the car . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

EN/3

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

1. Important information

Target group

The target group for these installation instructions is specialist staff trained on BMW cars.

All servicing, repair and installation work on BMW cars is completed at your own risk.

All work is to be carried out using current BMW

- Repair manuals

- Servicing manuals

- Work instructions

in a rational sequence with the prescribed tools (special tools) and taking into account the

relevant health and safety regulations.

Safety instructions

BMW cannot accept any liability for damage caused by a failure to follow the work and

instructions set out in these installation instructions. If the part is installed and used

improperly and not as set out in the installation instructions, all warranty claims to BMW

AG shall be rendered void. (The rubber pad on the BMW aluminium footrest must be

checked for signs of wear at regular intervals. A badly worn rubber pad must be replaced

by a new rubber pad since otherwise your safety cannot be guaranteed when you are

driving the car.)

The supplementary sheet supplied with the kit is to be placed in the car after the installation

of the BMW aluminium footrest.

Installation information

Only use the securing screws provided to secure the aluminium footrest plate.

Required tools and equipment

Drill

3 mm drill bit

Hammer

Centrepunch

Scissors

Torx screwdriver TX 10

Deburring tool

EN/4

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

2. Preparations

TIS instruction No.

Remove the door sill strip from the front left (interior) 51 47 000

Remove the trim for the pedals 51 45 185

Remove the side footwell trim on the left A pillar 51 43 070

Cut out the drilling template

EN/5

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

3. Teileübersicht

A Aluminium footrest plate 1x

B Rubber footrest pad 1x

C Torx screw K4 x 10 (self-tapping thread) 6x

D Drilling template (Order No. 01 29 0 136 496) 1x

F 46 0754 EVA

DBA

EN/6

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

4. To install the BMW aluminium footrest

Place the drilling template (D) on the surface of the

footrest (1) on the side footwell trim (2) in the

centre between the edge radius on each side.

Adjust the bottom right corner of the drilling

template until it is flush with the bottom edge of the

surface of the footrest (1). Mark the holes from the

drilling template (D) on to the surface of the

footrest (1) on the side footwell trim (2).

Remove the drilling template (D). Centrepunch the

holes (1), drill then with a 3 mm drill bit and deburr

them.

Press the rubber pad (B) into the aluminium plate

(A) from the rear. Secure the aluminium plate (A)

with the fitted rubber pad (B) to the surface of the

footrest (1) in the side footwell trim (2) using the six

Torx screws K4 x 10 (C). Tighten the Torx screws

K4 x 10 (C) by hand.

F 46 0755 EVA

F 46 0756 EVA

EN/7

Retrofit / Installation kit No. 51 47 0 027 792

Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001

5. To assemble the car

Assemble the car again following the instructions for its dismantling in reverse order.

BMW 51 47 0 027 792 Installation Instructions Manual

BMW 51 47 0 027 792 Installation Instructions Manual

BMW 51 47 0 027 792 Installation Instructions Manual

Related papers