HEARTH HOME technologies MOUNTAIN OAK-18 Operating instructions

Brand: HEARTH HOME technologies

Model: MOUNTAIN OAK-18

Type: Operating instructions

Hearth & Home Technologies • Mountain Oak Installation Instructions • 4625-905 Rev. A • 02/23

Log Placement Instructions

Models: MOUNTAIN OAK-18

WARNING!

The positioning of the logs is critical to the safe, clean operation of this gas log set. Sooting and other problems may

result if the logs are not properly positioned per these instructions. Failure to position in accordance with the diagrams

below, or failure to use only parts specically approved for this log set may result in property damage or personal injury.

2Hearth & Home Technologies • Mountain Oak Installation Instructions • 4625-905 Rev. A • 02/23

Hearth & Home Technologies

7571 215th Street West, Lakeville, MN 50044

www.hearthnhome.com

PLACE MOUNTAIN OAK-18 LOGS

1. Place Rear Log (#1) on rear support. Figure 1

2. Place Middle Log (#2) on middle support. Figure 2

3. Place Front Log (#3) in between burner and grate.

Figure 3

4. Rest Top Log (#4) in front and middle log cutouts. Figure

NOTE: Logs #1, #2 and #3 have ridges on the bottom which

secure the logs to burner frame. After installing each log,

check to be sure it is stable.

Figure 1 -

Place Rear Log

Figure 2 -

Place Middle Log

Figure 3 -

Place Front Log

Figure 4 -

Place Top Log

PLACE THE DECORATIVE ROCK

WARNING

DO NOT sprinkle volcanic rock on the logs

or around the pilot or the main burner. This

may cause sooting. Only place volcanic rock

on the oor of the replace.

During initial operation of the new heater,

burning logs will give o a paper burning

smell and orange ames will be present.

Simply open the windows for a few hours

to vent the odor.

Rear Log #1

Middle Log #2

Front Log #3

Top Log #4

HEARTH HOME technologies MOUNTAIN OAK-18 Operating instructions

HEARTH HOME technologies MOUNTAIN OAK-18 Operating instructions

HEARTH HOME technologies MOUNTAIN OAK-18 Operating instructions

Other documents