8
14
9
13
10
11
12
12
3
45
6 7
Materials
1
Standard,
2
screws,
3
plugs,
4
small bolt,
5
slightly larger bolt,
6
clamp,
7
cap.
Tools
8
Crosshead screwdriver,
9
drill (8 mm diameter),
10
crosshead bit,
11
Allen key (included,
12
drill,
13
spirit level,
14
pencil.
30 minutes 1 person 1 coffee
INSTALL SPEAKER STAND.
On a high note.
By loosening the bolts on the side of the stand
with the Allen key
11
included, turn and tilt the
speaker in the correct position.
You’ve finished! Or done, if you’re called Jan.
Mark off the holes on the wall through the two
holes of the plastic cap. After drilling, check that
it is hanging straight with the spirit level
13
.
Press the small cap
7
into the wall mount so
that you conceal the screws properly. en press
the stand
1
into the wall mount.
Use the 8 millimetre diameter drill
9
to drill two
holes about five centimetres deep. en press the
plugs
3
into the holes and screw the plastic cap in
place with the screws
2
.
On the back of the stand
1
is a plastic cap. Pull
it off. It can be tough, so it takes some power.
BBSSW22W
PREPARE THE STAND MARK OFF THE DRILL
HOLES
FIX THE STAND TURN AND TILT THE
STAND
HANG UP THE STAND
DRILL THE HOLES
1. 2. 3.
5. 6. 4.
Suitable surface:
Solid brick
Solid concrete
Drywall with wooden
pillars behind it
CHECKLIST.
You’re 50% there.
Prior to drilling:
Use the pipe locator to check
if there aren’t any pipes or
cables in the wall.
Coolblue isn’t liable for any damage, accidents,
or arguments with boy/girlfriends as a result of
incorrect installation. Not sure if you can do this
on your own? Ask a skilled installation expert
for advice. Secure the stand at the bottom with the
screwdriver
8
and a bolt
5
. After this, you
can place the speaker on the stand and secure it
at the top with the clamp
6
and the other small
bolt
4
.
Do you have a question?
Coolblue.nl/en/
customer-service
/
