INSTALLATION AND SETUP
Please read the product setup instructions carefully. Do not operate this product in windy
conditions.
Find a at area of either grass or gravel for your product. Do not set up your inatable on a
slope. Doing so may prevent the inatable from inating properly or standing correctly. It
may also present a safety hazard. Be sure that the area is clear of leaves, loose dirt and/or
standing water as any of these can stain the product or damage the fan.
Carefully remove the inatable and included items from the box. Set the stakes, ropes and
clips aside. You will need those after fully inating your inatable for the rst time.
Lay your inatable out on the ground. The fan will be on the back side of the inatable.
Ensure that the deation zipper on the back of the inatable is closed. Plug the fan into a
Class A GFCI-protected receptacle to start inating your inatable.
For your rst ination, you will need to help your inatable inate properly. Ensure that
all of the extremities are positioned correctly, untwisting anything that may have become
tangled during unpacking and setup. For taller inatables, you will want to connect the tie
downs to the upper fabric (or metal) loops before you fully inate. Otherwise, the loops
may be too high to reach.
When fully inated, locate all of the tie-down points around the base. Place a stake through
the loop and press the stake about 2/3 of the way into the ground (you will insert these
fully later). These stakes help hold the inatable upright and prevent the wind from moving
your inatable.
Note: If your inatable is taller than 10 feet, you will need assistance to safely
position and secure your inatable.
For inatables under 9-feet tall, install at least three upper tie downs. For inatables
over 10-feet tall, you will need to install four or more upper tie downs, depending on the
inatable.
Attach each rope to a clip and attach the clip onto the upper fabric or metal loops. (If clips
are not included, tie each rope to directly to the loop.) Tie the ropes to
the additional ground stakes and secure the stakes about 2/3 of the way into the ground
(you will insert these fully later).
The angle of the rope to the ground should be 45 degrees (see diagram above). To achieve
a 45-degree angle, the stake distance (SD) from the inatable should be roughly equal to
the loop height (LH) on the inatable.
To properly secure your inatable, install the upper tie downs according to the above
graphic. Note that two of the side tie downs must angle forward by at least 30 degrees.
Adjust stakes as needed to assure that the inatable is fully upright and positioned
correctly. When the inatable is correctly positioned and all stakes have been placed, push
all of the stakes fully into the ground.
To achieve a proper 45º Angle,
Stake Distance (SD) = Loop
Height (LH)
For example, if the Loop Height
(LH) is 6’,
the stake should be placed 6’
away from the inatable
-
1
-
2
Christmas Time 8′ Inflatable Angels User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Pool Warehouse Christmas Time 7ft Inflatable Santa Countdown Installation guide
-
Fraser Hill Farm FHFJMJESUS061-L User manual
-
Gemmy 21GM21216 Operating instructions
-
-
Disney 21GM20280 Operating instructions
-
-
BANZAI 90330 User guide
-
Little Tikes 607837 User manual
-
Little Tikes Racing Slides Waterpark™ User manual
-
Home Accents Holiday 21GM27143 Operating instructions
