Connect hose to machine
Insert hose in machine
and turn
countrerclockwise
until it locks in place.
Connect hose to spray gun
While holding the end of
the hose, pull the quick
connect sleeve back then
align spray gun air intake
and release.
AIR INTAKE
Please note:
We recommend testing with water first
before spraying clients to fine tune this
adjustment for the atomization desired.
To adjust the spray pattern you will need to
turn the horns on the nozzle only.
Please note: If you are unable to turn horns
you may need to loosen cap slightly. If this is
required hold horns in place while tighening
cap back to avoid horn movement.
To spray in a
vertical
movement
To spray in a
horizontal
movement
Fascination FX Quick Start Guide
Turn fluid knob clockwise until fully
tightened.
TIP: When making adjustments hold the
spray gun with the nozzle facing you.
Turn fluid knob counter-clockwise
up to 2 full turns.
Fluid Knob
Step 1 Step 2 Step 3
Attaching the hose Adjusting your solution dial setting spray pattern
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
JET JAT-500 Standard Spray Gun (HVLP) 505500 Owner's manual
-
-
-
Draper 100ml Gravity Feed HVLP Air Spray Gun Operating instructions
-
Vaper HVLP Touch-Up Paint Spray Gun Set Owner's manual
-
Haier 237410 User manual
-
Vaper 19220 User manual
-
Vaper HVLP User manual
-
Anest Iwata WIDER2L-10G2P User manual
-
DeWalt DWMT70779 User manual
