IKEA 904.470.58 User manual

LIVBOJ

English

Français

Español

6

16

28

6English

Charger features

• USB power adapter (5.0V, 2.0A) and USB Type-C

cable not included.

•Wirelessly charges Qi-certied devices.

•Certied according Qi 1.2.4BPP specication.

• Temperature and power monitor for safety.

• LED status indicator.

Instructions for use

• Connect the USB cable to the power adapter

and to LIVBOJ . Plug it into the wall socket.

•For wireless charging, place the device to be

charged on top of the plus sign (+) on the

charger. The device must be placed directly

over the plus sign (+) on the charger for the

charging function to work optimally. Note that

on some devices you may have to activate

7

wireless charging in settings.

• If your battery is completely discharged, it may

take a few minutes before it starts charging.

This is entirely normal. You can see that the

battery has begun charging when the battery

symbol appears on your phone.

LED indicator (see illustrations):

1. Power on: LED lights up for 1 seconds.

2. Charging: LED on.

3. Charging completed: LED on.

4. Error: LED flashes.

Good to know

•USB cable length and quality inuences

charging speed and performance.

•Devices may get warm during charging; this is

8

completely normal and they will gradually cool

down again after they are fully charged.

•Charging time may vary based on the device’s

battery capacity, charge level, the age of

the battery and the temperature in the

surrounding area.

• Charger storage temperature: -20°C to 25°C

(-4°F to 77°F).

•Charger operating temperature: 0°C to 40°C

(32°F to 104°F).

• Unplug the charger from the power source

before cleaning and when it is not in use.

To clean the charger, wipe with a moist cloth.

Never submerge the charger in water.

Recommended precautionary measures and

9

technical data: see the back of the charger.

Save these instructions for future use.

WARNING:

•Only charge devices that are Qi-certied

•The wall socket must be located near the

equipment and must be easily accessible.

• Only use in dry locations.

•Children should be supervised to ensure they

do not play with the product.

•Never use a damage or faulty USB cable for

charging, since this can damage the appliance

and harm your device.

10

Product servicing

Do not attempt to repair this product yourself,

as opening or removing covers may expose you

to dangerous voltage points or other risks.

TECHNICAL DATA

Type: E2130

Input: 5.0V DC, 2.0A USB Type-C

Indoor use only

Operating frequency: 112 KHZ - 148 KHz

Output power: 33 dBµA/m at 3m

Manufacturer: IKEA of Sweden AB

Address: Box 702, SE-343 81 Älmhult, SWEDEN

11

The ‘Qi’ symbol is a trademark of the Wireless

Power Consortium

RF EXPOSURE INFORMATION

According to RF exposure regulations, under

normal operations the end user shall refrain

from being closer than 10 cm from the device.

This device complies with Part 15 of the FCC

Rules and this device contains licence-exempt

transmitter(s)/receiver(s) that comply with

Innovation Science and Economic Development

Canada's licence-exempt RSS standard(s).

12

Operation is subject to the following two

conditions:

(1) this device may not cause harmful

interference, and

(2) this device must accept any interference

received, including interference that may

cause undesired operation of the device.

WARNING:

Any changes or modications to this unit not

expressly approved by the party responsible for

compliance could void the user’s authority to

operate the equipment.

13

NOTE:

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection

against harmful interference in a residential

installation.

This equipment generates, uses and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning

14

the quipment o and on, the user is encouraged

to try to correct the interference by one or more

of the following measures:

•Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on a

circuit dierent from that to which the receiver

is connected.

•Consult the dealer or an experienced radio/TV

technician for help.

15

The crossed-out wheeled bin symbol indicates

that the item should be disposed of separately

from household waste. The item should be

handed in for recycling in accordance with local

environmental regulations for waste disposal.

By separating a marked item from household

waste, you will help reduce the volume of waste

sent to incinerators or land-ll and minimize any

potential negative impact on human health and

the environment. For more information, please

contact your IKEA store.

16Français

Caractéristiques du chargeur

• Adaptateur USB (5.0V, 2.0A) et câble USB

Type-C non inclus.

•Recharge sans l les appareils certiés Qi.

•Certié conforme aux spécications Qi

1.2.4BPP.

•Contrôle température et charge pour plus de

sécurité.

•Voyant d’état LED.

Instructions d'utilisation

•Raccorder le câble USB à l’adaptateur et à

LIVBOJ, puis brancher à une prise de courant.

•Pour le chargement sans l, placer le

téléphone sur le signe (+) du chargeur.

L'appareil doit être placé précisément sur le

signe (+) du chargeur pour un chargement

17

optimal. Sur certains appareils, il est nécessaire

d’activer la fonction de chargement sans l

dans les paramètres pour que le chargement

fonctionne.

•Si la batterie est complètement déchargée,

elle peut mettre quelques minutes avant de

commencer à se recharger. Cela est tout à

fait normal. Lorsque le symbole de la batterie

apparaît sur le téléphone cela indique le début

du chargement.

Voyant lumineux LED (voir illustrations) :

1. En fonctionnement : la LED s’allume

pendant 1 secondes.

2. En chargement : la LED est allumée.

3. Chargement terminé : la LED est allumée.

4. Erreur : la LED clignote.

18

Bon à savoir

•La longueur et la qualité du câble USB

inuent sur la vitesse et la performance du

chargement.

• Il est tout à fait normal que les appareils

chauent au cours du chargement ; ils

refroidiront progressivement une fois qu’ils

seront entièrement chargés.

•La durée du chargement peut varier en

fonction de la capacité de la batterie de

l’appareil, du niveau de charge, de l’âge de la

batterie et de la température ambiante.

•Température de stockage du chargeur :

-20 °C à 25 °C (-4 °F à 77 °F).

•Température de fonctionnement du chargeur :

0 °C à 40 °C (32 °F à 104 °F).

19

•Débranchez le chargeur de la source

d’alimentation avant de procéder à son

nettoyage et lorsqu’il n’est pas utilisé.

Pour nettoyer le chargeur, essuyez-le avec un

chion humide. Ne jamais plonger le chargeur

dans l’eau.

Mesures de précaution recommandées et

données techniques.

Se reporter au dos du chargeur.

Conserver ces instructions en vue d’une

utilisation ultérieure.

20

ATTENTION :

•Ne charger que des appareils compatibles avec

la technologie Qi.

• La prise murale doit être proche de

l’équipement et facilement accessible.

• Utiliser dans des endroits secs uniquement.

•Veiller à ce que les enfants ne jouent pas avec

ce produit.

•Ne jamais utiliser pour le chargement un câble

USB endommagé ou présentant un défaut, car

cela peut abîmer l’équipement ainsi que votre

appareil.

Page is loading ...

IKEA 904.470.58 User manual

IKEA 904.470.58 User manual

in other languages

Related papers

Other documents