6’’ RAIN SHOWER HEAD
PRODUCT GUIDE
INSTALLATION TROUBLESHOOTING
CLEANING & MAINTENANCE
Remove old shower head from the shower arm.
Clean the threads on the shower arm. There can be
some residual thread sealing tape or mineral deposits
on the arm, which can be cleaned o using mild soap
and water and/or an old toothbrush.
Wrap the white Teflon tape around the shower
pipe evenly for 4 to 5 w raps clockwise.
Screw the new shower head onto the end of the shower
y.
Turn on the water and check for leaks. If leaks occur,
r.
To maintain proper working cleaning your
shower head is required when mineral deposits appear
on the spray openings. To clean mineral deposits, gently
rub the rubber nozzles on the face of the shower head
to dislodge.
To clean heavier deposits on your shower head, remove
shower head and soak face down in 1-2 cups of white
vinegar (use white vinegar only) for about 2-3 hours.
Do not clean or rinse any part with harsh chemicals,
heavy duty cleaners, or abrasives; this may damage the
parts or the finish.
SPECS
F Rainfall Shower
Material: ABS
Joint: Adjustable Brass Ball
Water Flow: • 1.8 GPM flow restrictor installed
• 2.5 GPM flow restrictor included
in the box
Nozzles:
Rubber nozzles (touch to clean)
Size:
6”
1
2
3
4
5
®
PROBLEM 2. Low water pressure or missing spra
Quick fix:
Further: Clean the screened washe r.
PROBLEM 1. Leaking at or near the ball joint.
Quick fix: your shower pipe, there is
your shower head and the ball
k
PIVOT SEAT is properly seated around the ball joint and that
the black O-ring is seated properl y.
CONNECTION CAP
firmly while making
certain that the
PIVOT SEAT is
nice and straight
1aMake certain that the
PIVOT SEAT is straight
and that the
O-RING is properly seated
(and not twisted)
Double-check that
everything is properly
including the
CONNECTION
with your
shower pipe
IF YOU HAVE ANY LEAKS
(and before you consider returning the product)
SIMPLY FOLLOW THESE STEPS BELOW:
1b
CONNECTION CAP
