Kidco G35-17 Extension User guide

Brand
Kidco
Model
G35-17 Extension
Type
User guide

This manual is also suitable for

Kidco G35-17 Extension:

The Kidco G35-17 Extension is a 17-inch optional extension for the G31 Wood Safeway® Gate. It is designed to extend the width of the gate by 17 inches, allowing it to fit openings from 43 inches to 60 inches wide. The extension is easy to install and can be added to the gate in just a few minutes. It is made of durable steel and is finished with a black powder coat for a long-lasting finish. This extension allows you to customize the size of your gate to fit your specific needs.

Note: Only one extension is recommended per gate.

Kidco G35-17 Extension:

The Kidco G35-17 Extension is a 17-inch optional extension for the G31 Wood Safeway® Gate. It is designed to extend the width of the gate by 17 inches, allowing it to fit openings from 43 inches to 60 inches wide. The extension is easy to install and can be added to the gate in just a few minutes. It is made of durable steel and is finished with a black powder coat for a long-lasting finish. This extension allows you to customize the size of your gate to fit your specific needs.

Note: Only one extension is recommended per gate.

Wood Safeway
®
Extension
Model G17c
Extensión Wood Safeway
®
Modelo G17c
Rallonge Wood Safeway
®
Modèle G17c
Bl. 3001-655 • G17c-0402
User Guide
FOLLOW THESE
INSTRUCTIONS
CAREFULLY AND
KEEP THEM FOR
FUTURE
REFERENCE
Important Information
1. Place extension between the two basic gate
sections.
Adjust gate sections, until gate is
approximately right width and adjustment holes
are aligned on top and bottom.
Place one set of screws and screw sockets in
top and bottom set of overlapping adjustment
holes nearest hinge side of gate and second set
ENG
Assembly
Model G17c- 17” optional extension for G31
Wood Safeway
®
Gate for openings 43” to
60”.
Only one extension recommended per gate.
of screws and screw sockets in overlapping
holes nearest locking side of gate. Tighten with
a screwdriver.
IMPORTANT
Gate must NOT be extended any further than
4 holes from spindle ends.
2.
Sections should fit without any distance
between bars.
2
LIRE ATTEN-
TIVEMENT CES
INSTRUCTIONS ET
LES CONSERVER
POUR POUVOIR
S’Y RÉFÉRER
ULTÉRIEUREMENT.
Remarques importantes
1. Placer la rallonge entre les deux sections de
la barrière de base.
Ajuster les sections de la barrière jusqu’à ce
qu’elle corresponde approximativement à la
bonne largeur et que les trous d’ajustement
soient alignés en haut et en bas.
Placer un jeu de vis et de douilles de vis dans
les trous d’ajustement supérieur et inférieur qui
se chevauchent au plus près du côté charnières
FRE
Assemblage
Rallonge en option modèle G17c- 43,2 cm pour
barrière G31 Wood Safeway® - ouvertures de
109 cm ou 152 cm.
Une seule rallonge recommandée par barrière.
de la barrière et un second jeu de vis et de
douilles de vis dans les trous qui se
chevauchent au plus près du côté verrouillage
de la barrière. Serrer avec un tournevis.
IMPORTANT
La barrière ne doit PAS être allongée à plus
de 4 trous à partir des extrémités des axes.
2.
Les sections doivent s’ajuster sans espace
entre les barres.
3
SIGA CUIDADO-
SAMENTE ESTAS
INSTRUCCIONES Y
CONSÉRVELAS
PARA SU REFE-
RENCIA FUTURA
Notas importantes
1. Coloque las extensiones entre dos seccio-
nes de la reja básica.
Ajuste las secciones de la reja hasta que la reja
tenga aproximadamente la anchura adecuada y
los orificios de ajuste se alineen en la parte
superior y en la inferior.
Coloque un conjunto de tornillos y manguitos
roscados en la parte superior e inferior de los
orificios de ajuste traslapados que se
encuentran más cerca del lado de la bisagra de
la reja y el segundo conjunto de tornillos y
Spa
Montaje
Modelo G17c- extensión opcional de 17" para
la reja G31 Wood Safeway® para aberturas de
43" a 60".
Se recomienda sólo una extensión por reja.
manguitos roscados en los orificios traslapados
que se encuentran más cerca del lado de cierre
de la reja. Apriete con un destornillador.
IMPORTANTE
La reja NO se debe extender más allá de 4
orificios desde los extremos del pivote.
2. Las secciones deben caber sin que haya
distancia entre las barras.
4
1.
2.
Basic gate half
part
Moitié de barrière
de base
Mitad de la reja
básica
17” Extension
Rallonge de 43.2
Extensión de 17”
Always bar
against bar
Toujours barre
contre barre
Siempre instale
barra contra
barra
Basic gate half
part
Moitié de barrière
de base
Mitad de la reja
básica
5
4 Screw Sockets
4 Douilles à vis
4 Manguito roscados
4 Screws
4 Vis
4 Tornillos
Adjustment holes
Trous de réglage
Orificios de ajuste
Parts Check List
Liste de contrôle des pièces
Lista de verificación de piezas
1 - 17” extension
1 – rallonge de 43.2 cm
1 - extensión de 17”
KidCo is a member of:
KidCo est un membre de:
KidCo es miembro de:
Made in Denmark for:
KidCo, Inc.
1013 Technology Way
Libertyville, IL 60048-5349
www.kidco.com
Phone 1-800-553-5529
Fax 1-800-553-0221
Bl. 3001-655 • G17c-0402
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Kidco G35-17 Extension User guide

Brand
Kidco
Model
G35-17 Extension
Type
User guide
This manual is also suitable for

Kidco G35-17 Extension:

The Kidco G35-17 Extension is a 17-inch optional extension for the G31 Wood Safeway® Gate. It is designed to extend the width of the gate by 17 inches, allowing it to fit openings from 43 inches to 60 inches wide. The extension is easy to install and can be added to the gate in just a few minutes. It is made of durable steel and is finished with a black powder coat for a long-lasting finish. This extension allows you to customize the size of your gate to fit your specific needs.

Note: Only one extension is recommended per gate.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers