27755 Stansbury St #300 | Farmington Hills, MI 48334 | USA | main: +1 248 853-5724
Date: August 9, 2021
User Manual Information for Flex Wireless Charging Pad Module
Flex Automotive USA Inc
27755 Stansbury Blvd, Ste 300
Farmington Hills, MI 48334, USA
Vehicle Manual
The Flex product Wireless Charging Pad Module (WCPM) will be provided directly to the vehicle
manufacturer and not to an end-user. The vehicle manufacturer will assemble the WCPM as part of the
vehicle. Therefore, Flex will not be supplying an end-user manual. Flex has provided the following text to
vehicle supplier for their consideration to be included in their vehicle’s manual.
FCC ID: 2AF5R-52192780
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
To ensure compliance with FCC RF exposure requirements this device must be installed to provide a minimum of 20cm
between the device and people.
Vehicle Installation
The WCPM is permanently installed into the front center console area in an automotive vehicle and is
only removable by a qualified service technician. The WCPM is not designed to be operation outside of
the vehicle. The WPCM mounts on the back side of the A-surface using four screws and designed to
connect to the vehicle wire harness and draw power from vehicle battery. LIN bus communications on
the vehicle bus harness are required for the WPCM to operate.
